TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

New throttle body and cable questions

Thread Tools
 
Search this Thread
 
Old Jun 7, 2009 | 03:38 PM
  #1  
lordmetalz28's Avatar
Thread Starter
Member
iTrader: (1)
 
Joined: Apr 2008
Posts: 482
Likes: 0
From: hudson valley, NY
Car: 1987 Z28 with iroc-z Package no.3
Engine: 350TPI
Transmission: 700r4
Axle/Gears: 3.73 posi
New throttle body and cable questions

so i installed a summit 52mm t-body cause my tps screw holes where striped and i used it as an excuse to buy a bigger one haha.. the install went smooth and i adjusted the tps dead on and the iac is good. and the car runs smooth with no problems at all.. my only 2 questions are #1- i have ram air boxes and after the install she is making a very loud suction noise very loud.. i figure theres no vaccum leaks cause she is running perfect as can be is this normal #2.. and also there is a bit of slack in my throttle and cruise control cables.. dont know if this affects anything but should there be slack???
Reply
Old Jun 8, 2009 | 11:21 PM
  #2  
lordmetalz28's Avatar
Thread Starter
Member
iTrader: (1)
 
Joined: Apr 2008
Posts: 482
Likes: 0
From: hudson valley, NY
Car: 1987 Z28 with iroc-z Package no.3
Engine: 350TPI
Transmission: 700r4
Axle/Gears: 3.73 posi
Re: New throttle body and cable questions

bump
Reply
Old Jun 11, 2009 | 12:59 PM
  #3  
Rolling Thunder's Avatar
Supreme Member
 
Joined: Mar 2008
Posts: 1,549
Likes: 1
From: CT
Car: 86 T/A, 83 Z/28
Engine: 5.0 TPI, 350 2 X 4 bbl
Transmission: 4 speed auto, 5 speed manual
Axle/Gears: 3.23 posi, 3.73 std
Re: New throttle body and cable questions

Well for starters the loud suction noise is common in TPI motors. I assume you've probably seen the air foils for the throttle bodies to help smooth out the air flow. Now im not saying that's what causing it as once you added the ram air box and got away from the factory set up it will have a different sound to it but overall they natrally make a bit of a noise like a vacuum leak. I would just check it over for a vacuum leak just in case. Next when you say you have have slack in the cables how much slack are we talking about?
Reply
Old Jun 11, 2009 | 05:01 PM
  #4  
lordmetalz28's Avatar
Thread Starter
Member
iTrader: (1)
 
Joined: Apr 2008
Posts: 482
Likes: 0
From: hudson valley, NY
Car: 1987 Z28 with iroc-z Package no.3
Engine: 350TPI
Transmission: 700r4
Axle/Gears: 3.73 posi
Re: New throttle body and cable questions

a very little amount.. i mean theres play there.. i can slide the throttle bracket about a quater of and inch back and forth on the linkage peg.. nothing insane like droopping lines.. also i dont thing there is any vaccum leaks there was and the car was running like shi$ but i took the t-body off removed the throttle plate that was to long and jamming it up and reinstalled it and it runs smooth a perfect now.. the idle is a bit high maybe 800 in drive at idel but to be honest i prefer it there..
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Azrael91966669
DIY PROM
25
Jun 20, 2017 04:04 AM
mdtoren
TPI
12
Aug 23, 2015 12:52 PM
mdtoren
Tech / General Engine
0
Aug 16, 2015 05:45 PM
bamaboy0323
Tech / General Engine
2
Aug 15, 2015 07:20 AM
ZZ42Fast
TPI
4
Aug 10, 2015 08:20 PM




All times are GMT -5. The time now is 05:31 AM.