whats the process of pulling the 2 fuel rails out?Everything else is off down to the rails.Do they seperate from the rail or intake or do i have to seperate the rails,because of the angle of the injectors? Just need some advice Thanks in advance

 

4 bolts hold the rails down, and the 2 fuel lines are connected at the front of the block, drivers side. once you have the rails unbolted and the fuel lines disconnected, you might have to pry them up a bit but they will release from the manifold. if they are factory they have clips retaining them at the rail, and they will move enough that you can pull the entire assembly without dismantling the 2 sides

 

got it Thanks and the motor is out apprciate the help