IDLING FEELS ROUGH ABOUT EVERY TWO SECONDS
Thread Starter
Junior Member
Joined: Jul 2007
Posts: 67
Likes: 0
From: COMPTON, CA
Car: CAMARO IROC-Z
Engine: 350 T.P.I
Transmission: 700r4
IDLING FEELS ROUGH ABOUT EVERY TWO SECONDS
well when my 1989 CHEV CAMARO IROC-Z is idling or even when you rev the engine you feel like a roughspot then goes away then again and so on its there all the time i was wondering if i can get some tips on what it might be
Member
iTrader: (1)
Joined: May 2010
Posts: 306
Likes: 0
From: Elm City, NC
Car: 87 IROC Z
Engine: 5.7
Transmission: 700R4
Axle/Gears: 3.27
Re: IDLING FEELS ROUGH ABOUT EVERY TWO SECONDS
Are you running an aftermarket chip. Hypertech, etc? If you have modified the car in any way it wont run right
Senior Member
Joined: Apr 2006
Posts: 685
Likes: 0
From: CT
Car: 1988 Iroc
Engine: 5.7L
Transmission: '96 T56, Hurst Shifter, Mech VSS
Axle/Gears: 3.45 9 Bolt
Re: IDLING FEELS ROUGH ABOUT EVERY TWO SECONDS
I had/have a similar problem. Through process of elimination, I have decided its probably the injectors. Let the car warm up then turn it off and ohm the injectors hot. If your numbers aren't in the 15-16ohm range you know you have bad injectors.
Just fyi my injectors ohmed out well, but they dont spray well which has given me problems. so what im saying is even if they ohm out well, they still could be contributing to your problem.
Good luck!
Just fyi my injectors ohmed out well, but they dont spray well which has given me problems. so what im saying is even if they ohm out well, they still could be contributing to your problem.
Good luck!
Thread Starter
Junior Member
Joined: Jul 2007
Posts: 67
Likes: 0
From: COMPTON, CA
Car: CAMARO IROC-Z
Engine: 350 T.P.I
Transmission: 700r4
Re: IDLING FEELS ROUGH ABOUT EVERY TWO SECONDS
thanks i was looking at my harmonic balancer and the ring around in one spot it seems to be popped out i also have another question im trying to buy copper head gaskets but its asking me for bore and thickness would you what i have to do to know all that to buy the proper one thanks
Thread
Thread Starter
Forum
Replies
Last Post




