Clutch, Hydralic Linkage problem?
Thread Starter
Junior Member
Joined: Jun 2002
Posts: 2
Likes: 0
Clutch, Hydralic Linkage problem?
Camaro Iroc-Z 1989 305 tpi (F engine) 5 spd. 77mm tran.
Just installed new clutch, pressure plate(clutch kit), lowered vehicle went to back it out from lift and extremely rough shifting almost no reverse shifting. Flywheel was machined to take out high spots, double check tranny install,etc..
I think problem is in hydralic linkage(master cylinder, slave cylinder). Anyone have this problem?
Just installed new clutch, pressure plate(clutch kit), lowered vehicle went to back it out from lift and extremely rough shifting almost no reverse shifting. Flywheel was machined to take out high spots, double check tranny install,etc..
I think problem is in hydralic linkage(master cylinder, slave cylinder). Anyone have this problem?
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
10
Aug 11, 2015 10:11 PM
rsrmoore
Transmissions and Drivetrain
1
Aug 7, 2015 08:44 PM