Well I just installed successfully the panhard bar and LCA's, now I am trying to do the poly tranny mount I got from Spohn.

My problem is that the studs that come with the new mount will not (a) screw into the tranny (the two side ones) because they are too big for the holes. And (b) the middle stud that sticks down below the crossmember is too big to go through the slot, it's too thick.

So after all the fuss I just put the old one back in. Now can someone please let me know what I should do next? thanks!!!

 

Use your original mount bolts to hold the mount to the trans; and file or grind the cross-member slot wider. Pretty basic stuff.

 

ok thanks I'll just have to do that then. It was late last night and I was too lazy to get the drill out.... Thanks....

 

i had the same problem, i just enlarged the slot in the crossmember

 

I had to do the same thing when installing my es mount. I just used a rat tail file.