I am building a hot rod with a 1988 Camaro T-5 and stock slave cylinder setup, and a non stock Willwwood MC. The slave cylinder is higher than the Master Cylinder(under floor) so I am going to attempt to bleed it off the bellhousing, so I can keep the slave cylinder below the MC. Any advice as to whether this will work or how to best do this??
Thanks

 

i use a pheniox v12. i've never had much luck bleeding the factory hydrolic set up.

 

"i use a pheniox v12"....
Where can I get one??

 

i got mine from northern tool, mail order. i think snap on sells then along with several other places.