Clutch Problems Help!!
Thread Starter
Supreme Member
iTrader: (17)
Joined: Jan 2005
Posts: 2,716
Likes: 3
From: Mobile, AL
Car: GTA
Engine: 383 HSR
Transmission: TH-700R4
Axle/Gears: 3.42
Clutch Problems Help!!
Heres the deal!! I took the tranny out of an 83 trans am, and put it into my 88' firebird that was a V6. heres the problem.
the 83 wasnt hydraulic and my 88 is!!! the V6 bell housing has the pushrod cylinder the V8 has nothing!!!
Is there an adapter plate or something that I can buy to make a non hydraulic clutch a hydraulic one? I cannot finish without some sort of closure on this!!!
the 83 wasnt hydraulic and my 88 is!!! the V6 bell housing has the pushrod cylinder the V8 has nothing!!!
Is there an adapter plate or something that I can buy to make a non hydraulic clutch a hydraulic one? I cannot finish without some sort of closure on this!!!
Joined: Sep 2005
Posts: 27,867
Likes: 2,429
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
No.
You need the right bell housing.
Or, you need the COMPLETE mechanical linkage; from the pedals to the BH.
Bell housings are a whole lot easier to come by, and you'll like the results a whole lot better than the other.
You need the right bell housing.
Or, you need the COMPLETE mechanical linkage; from the pedals to the BH.
Bell housings are a whole lot easier to come by, and you'll like the results a whole lot better than the other.
Thread Starter
Supreme Member
iTrader: (17)
Joined: Jan 2005
Posts: 2,716
Likes: 3
From: Mobile, AL
Car: GTA
Engine: 383 HSR
Transmission: TH-700R4
Axle/Gears: 3.42
You kidding me? I have been looking for a while now. The dealerships no longer sale bell housings for thirdgens (so they tell me) and no junk yards in the state of georgia have a T5 I am so lost its crazy
Thread
Thread Starter
Forum
Replies
Last Post
theshackle
Transmissions and Drivetrain
2
Aug 31, 2015 10:47 AM
db057
TBI
10
Aug 11, 2015 10:11 PM
rsrmoore
Transmissions and Drivetrain
1
Aug 7, 2015 08:44 PM