long 1st gear
Thread Starter
Senior Member
iTrader: (3)
Joined: Dec 2005
Posts: 522
Likes: 0
From: Fresno, CA
Car: 87 Iroc-Z
Engine: 5.7 350 TPI
Transmission: stage2 700r4
Axle/Gears: 2.73 for now
long 1st gear
Mines an 87 305...700R4 w/ 2.73 gears. The problem is that when I floor it 1st gear hangs on forever. Its like the engine is @ WOT for a couple seconds until it shifts to 2nd. When it shifts to 2nd the car flies!!....Is this how its supposed to be. I mean the engine seems like its going to blow before it kicks into 2nd. Ive adjusted the tv cable a couple times, and it seems correct. Anything else you guys can think of. If i let off the throttle a little bit it will kick into 2nd faster, but i loose rpms??...whats wrong..
Shift kit maybe??
Shift kit maybe??
Senior Member
Joined: Mar 2003
Posts: 966
Likes: 2
From: NE Ohio
Car: 83 Z28
Engine: 305 (LG4)
Transmission: THM700R4
Axle/Gears: 10 bolt, 3.23 non-LS
Move the TV cable 1 notch toward the front of the car. If it is worse, move it 2 notches toward the rear (effectively 1 notch back from where you had it.) Slight adustments like this are common and acceptable. Do not move it more than a couple notches from where you have it now.
Senior Member
Joined: Jan 2006
Posts: 793
Likes: 0
From: Michigan
Car: 1987 Trans Am
Engine: 5.0L TPI
Transmission: 700R4
Axle/Gears: Richmond 3.73
My 87 Trans Am shift out of 1st gear at 5500 rpms at WOT.
Keep that in mind. With a 2.73, it will take a little to get to 5500 rpms.
I have now changed my gear to a 3.73, and if shifts the same 5500 rpms.
Keep that in mind. With a 2.73, it will take a little to get to 5500 rpms.
I have now changed my gear to a 3.73, and if shifts the same 5500 rpms.
Thread
Thread Starter
Forum
Replies
Last Post
junkcltr
Tech / General Engine
6
Aug 2, 2019 11:12 PM
gixxer92
Engine/Drivetrain/Suspension Parts for Sale
5
Sep 1, 2015 04:32 PM




