9 inch question (posi, limited slip...)
Thread Starter
Member
Joined: Feb 2001
Posts: 236
Likes: 0
From: ICELAND
Car: 86 T/A
Engine: ZZ383
Transmission: TH700R4 Raptor
Axle/Gears: 2,7x -> 3.00 or 3.50
9 inch question (posi, limited slip...)
I know this is probably not the best place to ask about Ford stuff but I dont know of any good Ford groups and this is for my 86 TA.
I am going to install a 9" Ford in my TA and dont know what is best to buy to get the power to the ground. I was wondering if Truetrack was the best way to go?
My vehicle is 86 TA, ZZ383 425/460, Raptor 700R4, and 3.50 gearing and this is a street vehicle (weekend vehicle).
Thanks, Nonni
I am going to install a 9" Ford in my TA and dont know what is best to buy to get the power to the ground. I was wondering if Truetrack was the best way to go?
My vehicle is 86 TA, ZZ383 425/460, Raptor 700R4, and 3.50 gearing and this is a street vehicle (weekend vehicle).
Thanks, Nonni
Thread Starter
Member
Joined: Feb 2001
Posts: 236
Likes: 0
From: ICELAND
Car: 86 T/A
Engine: ZZ383
Transmission: TH700R4 Raptor
Axle/Gears: 2,7x -> 3.00 or 3.50
Its ok, we have some snow and the temp is around freezing point. The TA will not get out untill next spring!
Joined: Jan 2004
Posts: 1,761
Likes: 4
From: The "D"
Car: A Portly 85 Z28
Engine: 4.530 X 4.250 BBC
Transmission: under rated for this application
Axle/Gears: also under rated
Tru Trac by detroit locker would be a good choice. I have one in mine and it is quiet and has no clutches to wear, at the track it hooks dead square, I have never heard a noise out it and and I use full slicks with a trans brake and 700 HP engine... best compromise between a locker and a clutch posi
Supreme Member
iTrader: (7)
Joined: Jul 2000
Posts: 2,047
Likes: 2
From: Prince George, BC, Canada
Car: 89 GTA
Engine: 5.7L Supercharged
Transmission: T-56
Axle/Gears: Moser 9" 3.70
Detroit TrueTrack here also in my 9". So far I like it all though one time my tires were chirping around a corner at 70mph(little scarry), not sure if it needs to be broken in or not or mine is just tight from the factory. Anytime I want it to lock up it's just a matter of steping on it, hundred times better then the stock piece of **** I had before.
Trending Topics
Supreme Member
iTrader: (5)
Joined: Jan 2002
Posts: 13,622
Likes: 5
From: Orland Park, IL
Car: 1984 Z28
Engine: SLOW carbed ls
Transmission: TH400 with brake, 8" PTC converter
Axle/Gears: moser 9" 4.11
i'm going to be running a spool, but the tru trac is a nice piece for more of a cruiser
Thread
Thread Starter
Forum
Replies
Last Post
84z96L31vortec
Tech / General Engine
7
Aug 20, 2017 12:16 AM






