tooth contact pattern
Thread Starter
Junior Member
Joined: Oct 2006
Posts: 65
Likes: 0
From: los cabos baja california
Car: camaro z28 84
Engine: chevy 468
Transmission: th400
Axle/Gears: 9 inch 3.25/4.11,axles moser 31 spl
tooth contact pattern
9 inch was wondering if anyone had opinions on the tooth contact?
Member
Joined: Aug 2007
Posts: 206
Likes: 0
From: maryland
Car: 91 maro
Engine: 350
Transmission: 700r4
Axle/Gears: 373 locker
Re: tooth contact pattern
i would def have to be there if i told u id be lieing as it looks u need to go a lil tighter did u get gears? get it in there make sure u have no play in pinnion maybe 10 tho maybe not even a 16th on a tape measure i did this done good
Thread Starter
Junior Member
Joined: Oct 2006
Posts: 65
Likes: 0
From: los cabos baja california
Car: camaro z28 84
Engine: chevy 468
Transmission: th400
Axle/Gears: 9 inch 3.25/4.11,axles moser 31 spl
Re: tooth contact pattern
PHOTOS
opinions on the tooth contact?
GOOD OR BAD ---->TOOTH CONTAC
opinions on the tooth contact?
GOOD OR BAD ---->TOOTH CONTAC 
Moderator
Joined: Jul 1999
Posts: 17,262
Likes: 168
From: 51°N 114°W, 3500'
Car: 87 IROC L98
Engine: 588 Alcohol BBC
Transmission: Powerglide
Axle/Gears: Ford 9"/31 spline spool/4.86
Trending Topics
Thread Starter
Junior Member
Joined: Oct 2006
Posts: 65
Likes: 0
From: los cabos baja california
Car: camaro z28 84
Engine: chevy 468
Transmission: th400
Axle/Gears: 9 inch 3.25/4.11,axles moser 31 spl
Re: tooth contact pattern
I am welding rear end
(weding mig) opinions , ideas photos
Thread
Thread Starter
Forum
Replies
Last Post
dimented24x7
Transmissions and Drivetrain
7
Sep 17, 2015 06:58 AM
