ok i gota 305 700r4 tranny and its having an issue. when i stomp the gas itll shift great threw 1&2 but as it gets ready to go into 3rd it wont shift unless i let off the gas and stomp it again. wtf is going on? im at wits end with it. any help is appreciated
anybody got any ideaS?
is the TV cable set properly?
Quote:
as far as i know, im not sure how to tell if its correctOriginally Posted by //<86TA>\\
is the TV cable set properly? Junior Member
transtalker
Junior Member
close
- Join DateJun 2009
- LocationShelby,NC
- Posts:27
- iTrader Positive Feedback0
- iTrader Feedback Score(0)
- Car95 Suburban K1500
- Engine355 TBI,heads,cam,flowmaster exhaus
- Transmission4L60E custom rebuild, mod shift kit
- Axle/Gears3.08 front and rear
- Likes:0
- Liked:0 Times in 0 Posts
to check the tv cable you pull your throttle wide open then take your finger and see if you can pull the cable any further at wide open throttle you should not be able to pull it any further if you can pull it out further you will need to push the button on the cable down then move it in or out depending if it is too tight or to loose
if its to loose or to tight what will it do?
Junior Member
It will smoke your 3/4 clutch pack if it is loose, You want the cable to be tight.
Junior Member
transtalker
Junior Member
close
- Join DateJun 2009
- LocationShelby,NC
- Posts:27
- iTrader Positive Feedback0
- iTrader Feedback Score(0)
- Car95 Suburban K1500
- Engine355 TBI,heads,cam,flowmaster exhaus
- Transmission4L60E custom rebuild, mod shift kit
- Axle/Gears3.08 front and rear
- Likes:0
- Liked:0 Times in 0 Posts
there is a bracket that the cable runs thru from your transmission to your carburator or throttle body at the bracket there is a button on the cable push it down;on the other side of the bracket you will see a plastic sleve that sticks out over the cable this is your adjustment.if your cable is too loose you push the plastic sleve back towards fire wall , if it is to tight you move the sleve out towards front of car
