I put a t56 in my 91z28 and now I cant get the slave/clutch cylinder rod to go on the clutch pedal. the end of the rod has a plastic bushing of some sort and it doent fit at all. How did you guys get your on.

 

i took it off (the bushing) and used a c-clip to hold the rod from falling off the pedal nipple

------------------
1987 GTA 355, carbureted, TFS heads(non G2), 6-speed, McLeod clutch, 11.3:1, dual 3" flowmaster 2-chamber exhaust with NO tailpipes, 98 z-28 wheels, soon to be replacing weak 10 bolt with 12-bolt...gettin tired of breakin axles....

...Whatever turns your tires.....

 

thanks. that was what i was gonna go next. the end of the piece of the pedal has a groove around it to hold a c clip i think. do you know where i could get one without searching all over the city.

 

I did the same thing, but there was not a bunch of room for the c-clip. After it popped the second time, I removed the pedal, drilled a small hole near the c-clip groove and put it all back together. When it was all installed, I put a pin through the hole to make sure it doesn't come apart again.

------------------
1992 Pontiac Firebird 350/Six Speed
1987 Toyota Pickup 383/500+ HP

 

Auto zone or an equivalent should sell an assortment. Make sure it fits tightly, or youll have the problem I had with the rod popping off the pedal.

------------------
1987 GTA 355, carbureted, TFS heads(non G2), 6-speed, McLeod clutch, 11.3:1, dual 3" flowmaster 2-chamber exhaust with NO tailpipes, 98 z-28 wheels, soon to be replacing weak 10 bolt with 12-bolt...gettin tired of breakin axles....

...Whatever turns your tires.....