I am gearing up to get my new motor put in but first i need the transmission that will mount behind it....i wanna get the t56 obviously, but i wanna know what all will need to be done to get it to mount up behind my 350....it is a 4 bolt main, bored.30 over with afr heads and stage 3 port and polish job....thanks

there are a few threads on the conversion I believe. Its not a hard swap to do

i couldnt find one on the swap for a 350 small block...

Where did you find many threads NOT related to sbc ?

Virtually all of the threads here are referring to normal SBC, unless its on an LS1, and then you usually arent hearing any asking.

all the sbcs are the same pattern on the back. Whether they're a 305 or 350 or variations. So whatever thread you find will work. The only major thing you need to watch for is whether your motor has a 2 piece or one piece RMS. if 1 piece, can use stock flywheels for the application, if 2 piece then you are in need of a $$$$$$ flywheel.

??? There's a sticky lol on swap t56

Top of the trans page
My T56 Swap Thread....
11 pages

https://www.thirdgen.org/forums/tran...ap-thread.html

If it says LT1/LT4, it's about an 86 and newer SBC; they're identical in how the transmission and flywheel bolt up.

If you have specific questions not addressed there, ask them.

are you referring to me.. I was talking to who wrote OP that there's a sticky ??!?
The guy who I quote below !



I know theres a t56 sticky and thread in the trans section ???



I agree just ask also you can search I find it easier to search on google tho and add thirdgen at the end

As for the sticky posted by Vetteoz, it is very informative and most everything is answered in the first four pages. I have read it several times myself.

i'm not sure if those threads will work with his stage 3 port and polish job