So it appears I have to replace my headgaskets, and I figured a 260 cam from delta would be a good idea while the heads are off.

I was thinking that getting some LS1 or LS6 valvesprings would be a way to save some cash, anyone else done this?

If you have, what was your installed height?

Any other things I should do with the heads off? I have a timing set and water pump for the job aswell.

 

So.......I find it hard to believe nobody has _any_ thoughts on this at all.......

 

There are a lot of people that put those springs on the FWD heads...but Ive never heard of someone putting them on the iron heads. Not even sure if they would fit right.

 

only one way to find out.

 

Anybody have spring recomendations for a 260 cam with Iron heads then?

 

i belive the part number would be a comp cams 916 spring for the 2609 cam but id have to dbl check for ya