tire rub front drivers fender shroud
Thread Starter
Member
iTrader: (4)
Joined: Jan 2002
Posts: 257
Likes: 1
From: Laurel MD 20707
Car: 91 Camaro RS
Engine: GM PP crate 350
Transmission: 700r4
Axle/Gears: 3:42 spooled 10 bolt
tire rub front drivers fender shroud
rubs plastic trim nearest the door when turning left.
it does not on passenger side ,i got a BFH, but idk
where to hit anything.
it does not on passenger side ,i got a BFH, but idk
where to hit anything.
Joined: Aug 2006
Posts: 12,805
Likes: 107
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: tire rub front drivers fender shroud
What wheels do you have. How is your alignment. Too much caster can cause this problem. Don't hammer anything. If its a light rub, I would not even worry about it
Thread Starter
Member
iTrader: (4)
Joined: Jan 2002
Posts: 257
Likes: 1
From: Laurel MD 20707
Car: 91 Camaro RS
Engine: GM PP crate 350
Transmission: 700r4
Axle/Gears: 3:42 spooled 10 bolt
Re: tire rub front drivers fender shroud
These are the wheels, it rubs the driver side but not passenger, doesnt grind and i can only hear it with the window open on a quiet day. where do i hammer it?
Joined: Aug 2006
Posts: 12,805
Likes: 107
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: tire rub front drivers fender shroud
What are the wheel specs, width offset backspacing? Don't hammer anyything in the front, there is never a need to.
If its only one side, you should have the alignment checked
The wheels look like they are out a little too far, but I can't tell from the pic. Don't hammer things.
If its only one side, you should have the alignment checked
The wheels look like they are out a little too far, but I can't tell from the pic. Don't hammer things.
Thread
Thread Starter
Forum
Replies
Last Post
