Body General body information and techniques for restoration, repairs, and modifications.

Bad Fitment of ABS T-top Headliner....Anyone Else?

Thread Tools
 
Search this Thread
 
Old 07-25-2005, 08:23 AM
  #1  
Banned
Thread Starter
iTrader: (1)
 
Paul Riccioli Jr's Avatar
 
Join Date: Feb 2000
Location: Bound Brook, NJ USA
Posts: 1,198
Likes: 0
Received 1 Like on 1 Post
Car: 89 IROC-Z
Engine: 383
Transmission: 700R4
Bad Fitment of ABS T-top Headliner....Anyone Else?

I got my ABS headliner last week from one of the board sponsors and I have to say I am very disappointed with it's fitment. I have a t-top car and on all of the inside edges there are large, unsightly gaps. I tried shifting it around but when I fix one side the opposite looks bad...and the medium looks bad all around.

Has anyone else had this problem?
Old 07-26-2005, 03:36 PM
  #2  
Supreme Member

iTrader: (15)
 
Johnny Blaze's Avatar
 
Join Date: Oct 2003
Location: Charlestown, IN
Posts: 3,449
Likes: 0
Received 4 Likes on 4 Posts
Car: 1971 Camaro
Engine: 427
Transmission: TKO600
Axle/Gears: 3.73
I would like to know if anyone elase has had a problem like this. I am planning on ordering a headliner this week and would like to aviod any problems. Who did you get it from? Perhaps you should post this in the product review forum.
Old 07-26-2005, 06:01 PM
  #3  
Supreme Member

 
smokefan's Avatar
 
Join Date: Nov 2004
Location: Connecticut
Posts: 1,344
Likes: 0
Received 0 Likes on 0 Posts
Car: 86 IROC w/Danko bodykit, 1988 iroc vert, 1989 k1500 pickup 6" lift and 35" tires, 2002 chevy tahoe z71
Engine: 383 stealth ram, 305 tpi, 350 tbi, 5.3l
Transmission: T56, 700r4, 700r4, 4l460
yes i have the same problem with mine. bought the abs headliner from ebay. itwas brand new and when i got it it comes shipped rolled up. so after i let it lay out in the sun it took its form and it looked really decent until i put it in. looks like crap. i hated it so much that i deceird to go to a custom interior shop here and have them install it. it looks a little bit better but once the tops are off forget it. big gaps in the conners of the ttop bar.
Old 07-26-2005, 06:07 PM
  #4  
Member
 
Don 79 TA's Avatar
 
Join Date: Apr 2005
Location: Long Island NY
Posts: 447
Likes: 0
Received 0 Likes on 0 Posts
Car: Hers: 88 Formula 350
Engine: TPI
Transmission: Auto
Axle/Gears: 10 bolt Posi
i just put one in her car, it's a black one non t top
fit was really good
but it sorta gapped in the center by the rear view mirror
so i took a black screw, and screwed it up there

the driver side seat belt cover didn't fit the greatest, screwed that in too, but cracked the plastic

i HATE interior work
especially with the crappy quality of the stock pieces and clips they used on these cars

ohhhh wellllll
Old 07-26-2005, 06:31 PM
  #5  
Supreme Member

 
smokefan's Avatar
 
Join Date: Nov 2004
Location: Connecticut
Posts: 1,344
Likes: 0
Received 0 Likes on 0 Posts
Car: 86 IROC w/Danko bodykit, 1988 iroc vert, 1989 k1500 pickup 6" lift and 35" tires, 2002 chevy tahoe z71
Engine: 383 stealth ram, 305 tpi, 350 tbi, 5.3l
Transmission: T56, 700r4, 700r4, 4l460
yea i cna imagine that the full headliner fits alot better than the top ones do
Old 07-26-2005, 07:11 PM
  #6  
Supreme Member

iTrader: (1)
 
GodSpeedGTA's Avatar
 
Join Date: Jul 2004
Location: Lubbock, TX
Posts: 1,010
Likes: 0
Received 0 Likes on 0 Posts
Car: 1989 GTA
Engine: Future: LSX Turbo
Transmission: built T-56
name names...who did you use? I got mine from 1Aauto and havent put it on to see fitment...what companies did you buy yours from...if it doesnt fit write the company and demand either answers or your money back...they cant make you keep something that doesnt fit and looks like crap
Old 07-26-2005, 08:59 PM
  #7  
TGO Supporter

 
Sonar_un's Avatar
 
Join Date: Nov 2000
Location: Houston, TX
Posts: 2,201
Likes: 0
Received 0 Likes on 0 Posts
Car: '86 T/A
Engine: 350/LT1 Intake
Transmission: 700R4 - Built
Axle/Gears: 4th gen 3.42
I bought ABS headliner from Hawks and couldn't be more pleased with the fitment. Its like a work of art.

Here are some pics from when I got it first installed... 12/03

<img src="http://www.zbalan.com/sonarun/TransAm/newliner01.jpg">

<img src="http://www.zbalan.com/sonarun/TransAm/newliner02.jpg">

<img src="http://www.zbalan.com/sonarun/TransAm/newliner03.jpg">

Last edited by Sonar_un; 07-26-2005 at 09:01 PM.
Old 07-27-2005, 07:29 AM
  #8  
Member

iTrader: (13)
 
wilyk9's Avatar
 
Join Date: Aug 2002
Location: Sandusky, OH
Posts: 270
Likes: 0
Received 0 Likes on 0 Posts
Car: 85 Trans Am
Engine: 305 Carb
Transmission: 700R4
I also would like to know the vendor names that have the fitment problems as this is on my interior list to replace in the future. With Sonar_un posting a good fitting one from Hawks, sounds like it could be vendor specific?

Sonar_un, got any pics from above with the t-tops off? That sounds like the area with the problems the others are having.

Those with fitment problems, got any pics to post?
Old 07-27-2005, 08:57 AM
  #9  
Banned
Thread Starter
iTrader: (1)
 
Paul Riccioli Jr's Avatar
 
Join Date: Feb 2000
Location: Bound Brook, NJ USA
Posts: 1,198
Likes: 0
Received 1 Like on 1 Post
Car: 89 IROC-Z
Engine: 383
Transmission: 700R4
Hate to contradict the other poster, but my bad fitting one is from Hawks also.

Your pics from the inside look good but it's the top side that looks bad on mine. Got any pics of that?

I'm going to let mine sit for a week or so in the car and see if it takes shape any better....if not I'll give them a call.
Old 07-27-2005, 08:58 AM
  #10  
Supreme Member

iTrader: (15)
 
Johnny Blaze's Avatar
 
Join Date: Oct 2003
Location: Charlestown, IN
Posts: 3,449
Likes: 0
Received 4 Likes on 4 Posts
Car: 1971 Camaro
Engine: 427
Transmission: TKO600
Axle/Gears: 3.73
Anyone haveing fitment problems with non t top cars?
Old 07-28-2005, 10:22 AM
  #11  
TGO Supporter

 
Sonar_un's Avatar
 
Join Date: Nov 2000
Location: Houston, TX
Posts: 2,201
Likes: 0
Received 0 Likes on 0 Posts
Car: '86 T/A
Engine: 350/LT1 Intake
Transmission: 700R4 - Built
Axle/Gears: 4th gen 3.42
I scavenged up a pic from the top. Its not a great pic, but its all I have.

<img src="http://www.zbalan.com/sonarun/TransAm/viewfromtop.jpg">
Old 07-28-2005, 10:26 AM
  #12  
Banned
Thread Starter
iTrader: (1)
 
Paul Riccioli Jr's Avatar
 
Join Date: Feb 2000
Location: Bound Brook, NJ USA
Posts: 1,198
Likes: 0
Received 1 Like on 1 Post
Car: 89 IROC-Z
Engine: 383
Transmission: 700R4
Yeah it's hard to tell from that pic.
I spoke with Hawks yesterday and they told me to send them some pics so I'm going to get it in as best as possible and snap a few to send over their way.
Old 07-28-2005, 04:20 PM
  #13  
Supreme Member

 
smokefan's Avatar
 
Join Date: Nov 2004
Location: Connecticut
Posts: 1,344
Likes: 0
Received 0 Likes on 0 Posts
Car: 86 IROC w/Danko bodykit, 1988 iroc vert, 1989 k1500 pickup 6" lift and 35" tires, 2002 chevy tahoe z71
Engine: 383 stealth ram, 305 tpi, 350 tbi, 5.3l
Transmission: T56, 700r4, 700r4, 4l460
just to clean things up mine came from a1auto. it looks really nice until the tops are off. from the same pic view that sonar_un posted with the top off you wont be able to tell on mine until you are right on top of it. theres a gap in the corners
Old 07-28-2005, 08:32 PM
  #14  
TGO Supporter

 
Sonar_un's Avatar
 
Join Date: Nov 2000
Location: Houston, TX
Posts: 2,201
Likes: 0
Received 0 Likes on 0 Posts
Car: '86 T/A
Engine: 350/LT1 Intake
Transmission: 700R4 - Built
Axle/Gears: 4th gen 3.42
I inspected mine closely today (After a year of having it installed, hell, a year and a half). It looks ok to me, I don't notice any huge gaps or anything. Talk to Bruce at hawks, he will help you out.
Old 07-28-2005, 10:40 PM
  #15  
Supreme Member

 
smokefan's Avatar
 
Join Date: Nov 2004
Location: Connecticut
Posts: 1,344
Likes: 0
Received 0 Likes on 0 Posts
Car: 86 IROC w/Danko bodykit, 1988 iroc vert, 1989 k1500 pickup 6" lift and 35" tires, 2002 chevy tahoe z71
Engine: 383 stealth ram, 305 tpi, 350 tbi, 5.3l
Transmission: T56, 700r4, 700r4, 4l460
they arent big gaps by any means but you can tell that they are there when the tops are off. its about the size of a dime or so.
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
86Firebird86
Power Adders
36
12-26-2015 07:21 AM
dbrochard
Engine/Drivetrain/Suspension Parts for Sale
6
09-19-2015 08:13 PM
TrevinE
Electronics
1
09-14-2015 03:20 PM
IROCZDAVE (88-L98)
Exterior Parts for Sale
0
09-06-2015 06:23 AM
FLAP
Camaros Wanted
0
09-02-2015 09:22 AM



Quick Reply: Bad Fitment of ABS T-top Headliner....Anyone Else?



All times are GMT -5. The time now is 12:22 PM.