cc 82Z-28

iTrader: (7)

Ok, I'm getting ready to start the rear disc conversion on my Z-28 which involves changing to PBR setup. I have most everyting to do the swap and I have new hardware for the calipers, my questions is this, what's the trick to installing the spring for e-brake on the bracket? Also, I've read about the set screw that has gotten some people with adjustment but I see no set screw, maybe it is missing, I' not sure. It would sure help to see some pics of these two items so I have an idea what to do. I've never messed with rear discs brakes so this is new territory for me and I don't a manual to cover these brakes. I've read a lot of JamesC posts on doing this which has helped but these two things have me stumped. Thanks for the help.

cc 82Z-28

iTrader: (7)

Ok, I finally found the link that JamesC put in for just that procedure that EBMiller posted with pics, now all I have to do is give it a try.

JamesC

iTrader: (5)

In a pic that Ed Miller once posted, he's pointing at the screw.

JamesC

cc 82Z-28

iTrader: (7)

Thanks for posting that up, all I have to do is wait and see if I need the shims for centering the rotor up when I mock it up. JamesC you are a big help.

cc 82Z-28

iTrader: (7)

Well, just when you think you have it covered turns out I'm missing one of the little springs that hold tension on the piston. Probably been missing for some time, now I have to find one so I can continue.

cc 82Z-28

iTrader: (7)

The spring I am looking for is the one pictured in the this posting. Thanks if someone can get me one so I can get started on my conversion.