Brake warning light, linked to ECM?
#1
Junior Member
Thread Starter
Brake warning light, linked to ECM?
Deleted the ECM on an 85 firebird, I was expecting a permanent CEL after the delete but I'm also getting a "brake" warning light. Is this also tied to the ECM? I don't rember unplugging anything tied to the brake system is what has me confused.
#3
Junior Member
Thread Starter
Re: Brake warning light, linked to ECM?
Lever itself is disengaged, I'll check and see if the switch is stuck. Thank you
#4
Supreme Member
iTrader: (1)
Join Date: Feb 2017
Location: Meriden, CT 06450
Posts: 4,034
Received 517 Likes
on
431 Posts
Car: 84 TA orig. 305 LG4 "H" E4ME
Engine: 334 SBC - stroked 305 M4ME Q-Jet
Transmission: upgraded 700R4 3200 stall
Axle/Gears: 10bolt 4.10 Posi w Lakewood TA Bars
Re: Brake warning light, linked to ECM?
I'm not sure, but what about the switch on the brake distribution block? Is the wire still connected?
#5
Junior Member
Thread Starter
Re: Brake warning light, linked to ECM?
Yes the wire is still going to the block below the master cylinder, I didn't touch anything wiring wise except the ECM harness. I worked the park brake lever about 50 times and it went away, but now the light doesn't come on when I set the park brake. Think the switch is dead or the wire is faulty. Going to get a new switch and pull the center console.
Thread
Thread Starter
Forum
Replies
Last Post