camaroboy199290

Ok so I just bought a 350 that is a o piece rear seal roller block it also has the 194 160 fi heads. I'm using the rotating assembly that came in it cause it's a zz4 crate motor. I've gotten all the parts to put it in like the computer injectors and lil stuff. Now I just need to figure out a cam to put in it that dosnt require doing anything to the computer. I don't mind upgrading springs. So if anyone has suggestions on a cam I could use either roller or flat tappet. Any suggestions r greatly appreciated and i wouldn't mind buying a used roller cam just not a flat tappet one

vetteoz

iTrader: (13)

Does it have ZZ4 heads ?

camaroboy199290

I'm not worried about the heads I just wanna no. Cam I can use with my stock computer nd get good power

five7kid

iTrader: (14)

If you match parts correctly, you should be able to use the computer. Might require tuning to make it better, though.

camaroboy199290

Well the heAds r the swirl port or something like that fi heads with the 194 valves and eventually I wouldn't mind doin the computer but it's still my dd and I want it to run good

vetteoz

iTrader: (13)

What casting # on the heads?

camaroboy199290

Sory took a lil while to get on here but the head numbers r 14102193

five7kid

iTrader: (14)

350 TBI swirlport heads. Fine for a mild daily driver, not so good if you want to race.