Ok so I just bought a 350 that is a o piece rear seal roller block it also has the 194 160 fi heads. I'm using the rotating assembly that came in it cause it's a zz4 crate motor. I've gotten all the parts to put it in like the computer injectors and lil stuff. Now I just need to figure out a cam to put in it that dosnt require doing anything to the computer. I don't mind upgrading springs. So if anyone has suggestions on a cam I could use either roller or flat tappet. Any suggestions r greatly appreciated and i wouldn't mind buying a used roller cam just not a flat tappet one

 

Does it have ZZ4 heads ?

 

I'm not worried about the heads I just wanna no. Cam I can use with my stock computer nd get good power

 

If you match parts correctly, you should be able to use the computer. Might require tuning to make it better, though.

 

Well the heAds r the swirl port or something like that fi heads with the 194 valves and eventually I wouldn't mind doin the computer but it's still my dd and I want it to run good

 

What casting # on the heads?

 

Sory took a lil while to get on here but the head numbers r 14102193

 

350 TBI swirlport heads. Fine for a mild daily driver, not so good if you want to race.