Airpak

Hey, I have exhaust pipes that curve down on the ends and they dont stick out at all so i wanted to put sum exhaust tips on them, but i dont know what kind your supposed to get for downward exhuast?
do i just get ones that are curved upwards a bit?

RebelTillDeath3

You cut off the angled down part and weld them on the straight part of piping.

neubauej

What he said

RebelTillDeath3

Here's a pic of mine to help a little........


See how far back they're mounted? If I had angled down tips originally, they'd be completely cut off anyways.

Airpak

ack
but it looks like if i cut if off and put a straight one on it wont fit.
iuno.

RebelTillDeath3

Get a bigger ID inlet on the tips so they can hang down a little bit. I went 1/2" bigger on the inlet of my tips so I could have an opening at the bottom of the joint of the tip and exhaust so water could pass through instead of going in my muffler.

camarors8992

i want to put on the straight tips that are 24 inches long but if you cut the curve off the tail pipe the pipe is at a slight upward angle wouldnt the tip hit the rear bumper or be really close and warp the paint

Airpak

what do you cut exhaust pipes with?

excuse my newbness.

RebelTillDeath3

Sawsall. You can do it with a handsaw too, I did that, it started pouring down rain when I was putting in my cutout so I didn't want to get electricuted with the sawsall, so I used a handsaw.