Best place to mount after market gauges..
#1
Supreme Member
Thread Starter
Join Date: Jul 2006
Location: Windsor Ontario
Posts: 1,674
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1987 Firebird Formula
Engine: 2004 LQ4
Transmission: T-5 WC
Axle/Gears: 3.42
Best place to mount after market gauges..
Without looking like Paul walker drives my car..
Honestly, When I was in my car removing that horrible EFI wiring harness, I may have become a little bit... Cutter happy..
I hacked off my temp sensor for my gauge, and I really cannot find it.. So I bought a really nice autometer knock off..
Where is a good place to mount gauges in these cars? I don't really want anything too noticeable, but I want to be able to check it while driving.
Honestly, When I was in my car removing that horrible EFI wiring harness, I may have become a little bit... Cutter happy..
I hacked off my temp sensor for my gauge, and I really cannot find it.. So I bought a really nice autometer knock off..
Where is a good place to mount gauges in these cars? I don't really want anything too noticeable, but I want to be able to check it while driving.
#2
Member
iTrader: (6)
Join Date: Feb 2000
Location: Valley Center,Kansas
Posts: 404
Likes: 0
Received 0 Likes
on
0 Posts
Car: 92RS
Engine: LS 402 inwork
Transmission: TH350
Axle/Gears: 10 bolt,3:73's
Re: Best place to mount after market gauges..
Right below the center vents is a safe place. I have a triple gauge mount there in mine.
#5
Junior Member
Join Date: Jul 2009
Location: Point Pleasant, NJ
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
Car: 86 Trans Am
Engine: 350 TPI
Transmission: 700r4
Axle/Gears: 3.23
#6
Supreme Member
Thread Starter
Join Date: Jul 2006
Location: Windsor Ontario
Posts: 1,674
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1987 Firebird Formula
Engine: 2004 LQ4
Transmission: T-5 WC
Axle/Gears: 3.42
Re: Best place to mount after market gauges..
Now if it makes any difference.. I technically have no more heat or AC, perhaps I could utilize that space where the controls are..
#7
Supreme Member
Thread Starter
Join Date: Jul 2006
Location: Windsor Ontario
Posts: 1,674
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1987 Firebird Formula
Engine: 2004 LQ4
Transmission: T-5 WC
Axle/Gears: 3.42
Re: Best place to mount after market gauges..
Decided against the Equiis gauge, going with two autometers, one a water temp, the other a vacuum gauge.. I'm going to put them where my heater controls should be!
Trending Topics
#8
Junior Member
Join Date: Jul 2010
Location: Jefferson City, MO
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Z28
Engine: 358 SBC
Transmission: 700r4
Axle/Gears: 373 auburn posi 28 spline
Re: Best place to mount after market gauges..
Here is the custom switch panels and gauge settup in my 87 z28. Not the best picture, doesnt really show how good the aluminum looks. I really love the way it came out. Took a while to do all by hand but well worth it to me. Autometer gauges with angle rings face them towards the driver. And dont make fun of my firebird streering wheel lol i have since changed it. What you guys think?
Last edited by Caleb_90; 03-09-2011 at 06:55 PM.
#9
Supreme Member
Thread Starter
Join Date: Jul 2006
Location: Windsor Ontario
Posts: 1,674
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1987 Firebird Formula
Engine: 2004 LQ4
Transmission: T-5 WC
Axle/Gears: 3.42
Re: Best place to mount after market gauges..
Here is the custom switch panels and gauge settup in my 87 z28. Not the best picture, doesnt really show how good the aluminum looks. I really love the way it came out. Took a while to do all by hand but well worth it to me. Autometer gauges with angle rings face them towards the driver. And dont make fun of my firebird streering wheel lol i have since changed it. What you guys think?
#10
Junior Member
Join Date: Jul 2010
Location: Jefferson City, MO
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Z28
Engine: 358 SBC
Transmission: 700r4
Axle/Gears: 373 auburn posi 28 spline
Re: Best place to mount after market gauges..
Yeah I like it looks clean and simple. Glad to help
#12
Supreme Member
Thread Starter
Join Date: Jul 2006
Location: Windsor Ontario
Posts: 1,674
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1987 Firebird Formula
Engine: 2004 LQ4
Transmission: T-5 WC
Axle/Gears: 3.42
Re: Best place to mount after market gauges..
Now the question I'm dieing to ask..
How did you run the wires/hoses for your gauges through the firewall?
Where did you drill, and what did you use to fill it up.
How did you run the wires/hoses for your gauges through the firewall?
Where did you drill, and what did you use to fill it up.
#14
Junior Member
Join Date: Jul 2010
Location: Jefferson City, MO
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Z28
Engine: 358 SBC
Transmission: 700r4
Axle/Gears: 373 auburn posi 28 spline
Re: Best place to mount after market gauges..
I drilled just a little off center by the driver side head down low. Just used a rubber grommet to seal it up. I will try to get a picture up when I get home later tonight
#15
Junior Member
Join Date: Jul 2010
Location: Jefferson City, MO
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
Car: 87 Z28
Engine: 358 SBC
Transmission: 700r4
Axle/Gears: 373 auburn posi 28 spline
Re: Best place to mount after market gauges..
Here you go. Not the best pictures but they work. Pretty much right behind the driver side cylinder head.
7c7a64e5.jpg?t=1299814392
Another one from the top. You can see i have a few different things coming out of the one on the right and my nitrous line is coming out of the left one.
1ded9685.jpg?t=1299814392
And i had to throw in the last one just cause i want to show off my new carb. Its preaty lol
7c7a64e5.jpg?t=1299814392
Another one from the top. You can see i have a few different things coming out of the one on the right and my nitrous line is coming out of the left one.
1ded9685.jpg?t=1299814392
And i had to throw in the last one just cause i want to show off my new carb. Its preaty lol
#16
Supreme Member
Thread Starter
Join Date: Jul 2006
Location: Windsor Ontario
Posts: 1,674
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1987 Firebird Formula
Engine: 2004 LQ4
Transmission: T-5 WC
Axle/Gears: 3.42
Re: Best place to mount after market gauges..
Thanks man, that saves me a bunch of time figuring out where to drill!
Hopefully Autogage gives me enough line on the RTD to get to my passenger side head, I have a fan controller in the other port!
Hopefully Autogage gives me enough line on the RTD to get to my passenger side head, I have a fan controller in the other port!
#19
Supreme Member
iTrader: (5)
Join Date: Jan 2009
Location: league city
Posts: 2,928
Likes: 0
Received 3 Likes
on
3 Posts
Car: SOLD!!!!!
Re: Best place to mount after market gauges..
http://www.summitracing.com/parts/ATM-20029/
i bought it. i trimmed the edges so that the tips would be flush. also trimmed a little off the back to make it shorter. after that it worked really good.
i bought it. i trimmed the edges so that the tips would be flush. also trimmed a little off the back to make it shorter. after that it worked really good.
Thread
Thread Starter
Forum
Replies
Last Post
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
0
09-02-2015 08:49 AM
IROCZDAVE (88-L98)
Engine/Drivetrain/Suspension Parts for Sale
0
09-02-2015 08:43 AM