LTX and LSXPutting LT1's, LS1's, and their variants into Third Gens is becoming more popular. This board is for those who are doing and have done the swaps so they can discuss all of their technical aspects, including repairs, swap info, and performance upgrades.
Welcome to ThirdGen.org!
Welcome to ThirdGen.org.
You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to post topics, communicate privately with other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join the ThirdGen.org community today!
how do i bypass the steam pipe coming out from underneath the throttle body? trying to hide or get rid of as many lines and hoses as possible for a cleaner look.
This ad is not displayed to registered members. Register your free account today and become a member on ThirdGen!
Sponsored Links
Registered users do not see this ad. Click here to register for free!
This is an ls1 as well - but another way of doing it. Might not accomplish your goals of reducing clutter though... Just some bent alluminum pipe and a little hose
Click to embiggen.
I drilled and tapped the back of the waterpump under the thermostat for a 1/4" pipe thread. I used a 90 degree hose barb fitting and ran the hose to that. I have been running this set up for 8 years with no problems.
Kory
You MUST have a steam setup up top. You CAN plug the rear holes w/ blocks that came one all 03+ LSx motors, then theres a cross over across the front w/ a outlet you can run to the rad/top of the waterpump.
