Engine Stalling
#1
Member
Thread Starter
Join Date: Feb 2002
Location: Orlando, FL
Posts: 174
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro RS
Engine: Was 305 LO3 TBI, now carbed 355
Transmission: Auto
Engine Stalling
I have a 9:1 355 with a Comp 268H cam in it. I'm using a 600 Holley on top (for monetary reasons) and a performer RPM manifold. It idles fine at around 1000 RPM, but once I put it in drive, it stalls. Any ideas? Timing's at 12 degrees before as per Comp's instructions.
Also, the thing's only pulling 11'' of vacuum. Not sure if that's relevant (as I'd imagine it's the cam), but figured I'd put it in here anyway.
Also, the thing's only pulling 11'' of vacuum. Not sure if that's relevant (as I'd imagine it's the cam), but figured I'd put it in here anyway.
#3
Member
Thread Starter
Join Date: Feb 2002
Location: Orlando, FL
Posts: 174
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1991 Camaro RS
Engine: Was 305 LO3 TBI, now carbed 355
Transmission: Auto
Haven't checked compression.
Had the motor assembled by a machine shop here...so they installed the cam.
Had the motor assembled by a machine shop here...so they installed the cam.
Thread
Thread Starter
Forum
Replies
Last Post