The trunk motor won't engage.
08-10-2006, 04:53 PM
#1
Member
Thread Starter
Join Date: Oct 2004
Location: Indiana
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Camaro Z28
Engine: 5.7 TPI L98
Transmission: 700R4
Axle/Gears: 3.23
The trunk motor won't engage.
I noticed today that when I went to close my trunk the motor didn't work at all, no noise. I'm thinking the motor is shot. I know the fuse isn't blown b/c the button that opens the trunk still works. Any help is greatly appreciated.
08-10-2006, 05:44 PM
#2
Junior Member
Join Date: May 2006
Location: Long Island
Posts: 39
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1987 gta T/A
Engine: 5.0 TPI
Transmission: 700R4
Axle/Gears: 3:23
Most likely it's the motor. I had the same problem except the motor on my car still ran. Turned out the plastic gear beside the motor was chewed up so I replaced it. The motor is seperate from the gear, so I'm geussing all you need is a motor.
08-10-2006, 07:30 PM
#3
Member
Thread Starter
Join Date: Oct 2004
Location: Indiana
Posts: 189
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1992 Camaro Z28
Engine: 5.7 TPI L98
Transmission: 700R4
Axle/Gears: 3.23
Well I was messing around with it and suddenly the motor engaged again. What happened was the wire that came from the sending unit was loose. So with a little duct tape I was able to keep it in place and keep it from shaking loose. Thanks for the advice though.
Thread
Thread Starter
Forum
Replies
Last Post
1992rs/ss
Engine/Drivetrain/Suspension Parts for Sale
16
01-28-2016 09:58 PM
