what do u think of this combo?
#1
Member
Thread Starter
Join Date: Oct 2003
Posts: 126
Likes: 0
Received 0 Likes
on
0 Posts
Car: 67 camaro
Engine: 383 accel dfi
Transmission: t56
what do u think of this combo?
tell me waht u guys think of this combo for my 67.its going to be a 383 stroker motor.eagle cast stroker kit with -5cc flat tops.heads are going to be afr 190's(not sure if i should go with 74 cc or 64 cc chambers let me know on that one)i have a few cams that i am looking at one is the lunati hr11 specs are @.050" dur intake:226 exh.234 lift @valve is intake.530 exh. .530 lobe sep 112deg. dd200 says 506ftlb@3500 rpm and 429hp@5000 rpm.now the other 2 cams are also lunati specs are pretty close to this one.this is going to be a tpi motor(ported out)and a t56 trans.this car will never see track time so i probably won't rev it past 5000rpm anyway.i know dd2000 is optimistic but what should i expect out of this combo in real life at the wheels?also looking to get about 10:1 compression.this is a HYDRAULIC roller cam by the way.let me know all of your opinions good and bad. i really want a killer street motor.also i have an accell dfi i am going to use on this. also large tube headers with flowmasters.
#2
Supreme Member
Join Date: Sep 1999
Location: Ohio, USA
Posts: 1,054
Likes: 0
Received 0 Likes
on
0 Posts
Car: 2015 Camaro Z/28 & 2013 Super Bee
Engine: LS7 and 392 HEMI
That cam is too big for a stock TPI, ported or not. If you really don't want to rev much past 5000 rpm, check out the LPE 211/219, it works great w/ TPI. Otherwise, I really wouldn't go past a 220/220-ish cam if you plan on keeping the TPI. A 226/234 cam will want to make power WELL past 5000 rpm, prob better to 6000-6500 rpm actually.
Last edited by BuckeyeROC; 12-07-2003 at 07:53 PM.
Thread
Thread Starter
Forum
Replies
Last Post
roysatikas
Transmissions and Drivetrain
0
09-22-2015 08:15 PM