Need measurements For badges
Thread Starter
Supreme Member
iTrader: (12)
Joined: Aug 2005
Posts: 1,923
Likes: 3
From: M.D
Car: 1987 Camaro
Engine: 350 hsr
Transmission: 700R4(blown)
Axle/Gears: 3:73
Need measurements For badges
I Need measurements of badges that go on the GFX(sides) and the rear of an 87 camaro
I Need measurements For the rectangle that the badges sit in
please help me out
Green boxes is what I am talking about.
I Need measurements For the rectangle that the badges sit in
please help me out
Green boxes is what I am talking about.
Joined: Mar 2002
Posts: 587
Likes: 1
From: middle TENNESSEE
Car: 1989 Iroc rebuild
Engine: 355 carb'd
Transmission: 5spd
Axle/Gears: 3:08 pos for a while
Re: Need measurements For badges
???? on all my gfx,90-92 and earlier there are indentations for the emblems?
Junior Member
Joined: Jan 2008
Posts: 62
Likes: 0
From: Tracy, California
Car: 1987 Iroc-Z
Engine: 305 TPI LB9
Transmission: Borg Warner T-5 5 Speed
Axle/Gears: Borg Warner 9 Bolt 3.45 LS
Re: Need measurements For badges
The measurements for the lower side skirt one's are:
6 3/4" long X 1 3/8 height...
The rear bumper one 6 1/2" long to the end of the Z-28 logo or 8 1/4 long to the end of the chevy logo and 1 3/16" height...
6 3/4" long X 1 3/8 height...
The rear bumper one 6 1/2" long to the end of the Z-28 logo or 8 1/4 long to the end of the chevy logo and 1 3/16" height...
Trending Topics
Thread Starter
Supreme Member
iTrader: (12)
Joined: Aug 2005
Posts: 1,923
Likes: 3
From: M.D
Car: 1987 Camaro
Engine: 350 hsr
Transmission: 700R4(blown)
Axle/Gears: 3:73
Re: Need measurements For badges
sorry i thought this was the right place, please move to be correct.
Thread
Thread Starter
Forum
Replies
Last Post
Elephantismo
Electronics
14
Feb 13, 2019 12:51 AM