Mirros wiggle
Senior Member
iTrader: (2)
Joined: Nov 2002
Posts: 774
Likes: 0
From: Idaho Falls
Car: 82 Trans Am
Engine: LTX
Transmission: T56
Axle/Gears: 3.42 strengthed 7.5 inch
depends on how it wiggles.. the glass section is held on to the plastic mirror retainer via adhesive strips.. these could be letting go, if they do.. well there goes your mirror.. it happened to one of mine.
if this is the problem you should be able to pry the mirror off the plastic backing plate (carefully) then clean the backing plate and cut a bunch of 3m double sided foam tape or similar and use it to put the mirror back on..
if this is the problem you should be able to pry the mirror off the plastic backing plate (carefully) then clean the backing plate and cut a bunch of 3m double sided foam tape or similar and use it to put the mirror back on..
Supreme Member
Joined: Jan 2001
Posts: 1,141
Likes: 0
From: Phoenix, AZ, USA
Car: 1991 T/A - Sold (sniff) 1980 T/A Pa
If the glass is secure to the plastic it's stuck to, there are 3 Phillips head screw that hold the plastic "movable" assembly into the metal outer assembly. You can access the screws by adjusting the mirror. Make sure those are tight.
HTH!
HTH!
Thread
Thread Starter
Forum
Replies
Last Post
Elephantismo
Electronics
14
Feb 13, 2019 12:51 AM
gta892000
Cooling
6
Sep 16, 2015 12:37 AM
89 formula TPI
Tech / General Engine
2
Sep 7, 2015 10:19 AM




