how do i get my ground effects off
Thread Starter
Junior Member
Joined: Mar 2006
Posts: 10
Likes: 0
From: Whiting Indiana
Car: 1989 IrocZ
Engine: 5.0 TPI
Transmission: 700r4
Axle/Gears: 3.43 rear disc brakes
how do i get my ground effects off
sanding my car and i realy need to know how to take the ground effects under the door off can anyone help?
Member
iTrader: (1)
Joined: Feb 2005
Posts: 266
Likes: 0
From: Rapid City, SD
Car: 89 Camaro RS/SS
Engine: LT1
Transmission: T-56
Axle/Gears: 10 bolt with 3.42
The piece on the actual door you have to take the door trim off and there's nuts inside of the door. For the side skirts there are several screws underneath, two underneath the emblems where it would say z28, and one at the other end that goes into where the back seat is. You have to take some of the interior trim off to get at that bolt. It's a 11mm nut and you'll need a deep socket.
Thread Starter
Junior Member
Joined: Mar 2006
Posts: 10
Likes: 0
From: Whiting Indiana
Car: 1989 IrocZ
Engine: 5.0 TPI
Transmission: 700r4
Axle/Gears: 3.43 rear disc brakes
took off all the out side bolts on the bottom so under the iroc sym. and where under the seat huh?
Member
Joined: Jul 2003
Posts: 148
Likes: 0
From: Baton Rouge, La
Car: 88 sport coupe convert
Engine: 305 tb
Transmission: auto
And if it would be a convertible it's almost impossible to get to. I have the same problem (88 convert) and could never get to the nut any kind of way.
Trending Topics
Member
Joined: Jul 2003
Posts: 148
Likes: 0
From: Baton Rouge, La
Car: 88 sport coupe convert
Engine: 305 tb
Transmission: auto
And if it would be a convertible it's almost impossible to get to. I have the same problem (88 convert) and could never get to the back nut any kind of way.
Thread
Thread Starter
Forum
Replies
Last Post
Damon
Tech / General Engine
8
Sep 26, 2015 04:29 PM