Will these work?
Thread Starter
Member
iTrader: (1)
Joined: Oct 2010
Posts: 347
Likes: 0
From: Virginia Beach, VA
Car: 1985 Firebird S/E
Engine: SBC 350, mild cam Vortec heads
Transmission: Rebuilt 700R4 vette servo+shift kit
Axle/Gears: 3.73
Will these work?
replacing the wheel wells in my 87 camaro will these tubs work?
http://www.jegs.com/i/Jegster/550/40525/10002/-1
http://www.jegs.com/i/Jegster/550/40525/10002/-1
Member
Joined: Nov 2010
Posts: 114
Likes: 0
From: St.Cloud, FL
Car: '85 Sport Coupe/Z28
Engine: N/A 350
Transmission: TH350
Axle/Gears: Factory 10-bolt w/3.08
Re: Will these work?
Depends, how good are you at fab work? If you are determined and are good at fabbing, then yes, they will. Or were you asking about the size?
Thread Starter
Member
iTrader: (1)
Joined: Oct 2010
Posts: 347
Likes: 0
From: Virginia Beach, VA
Car: 1985 Firebird S/E
Engine: SBC 350, mild cam Vortec heads
Transmission: Rebuilt 700R4 vette servo+shift kit
Axle/Gears: 3.73
Re: Will these work?
yeah size wise i am ordering them someone else is installing either a friend of a friend and if he doesnt turn up in time then the body shop when the car goes out for paint
Joined: Aug 2006
Posts: 12,805
Likes: 107
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: Will these work?
those tubs are not structural, so no, unless you are planning a cage and other chassis work, they wonr do it for you.
which wheel well are you working on, rear for front?
which wheel well are you working on, rear for front?
Thread Starter
Member
iTrader: (1)
Joined: Oct 2010
Posts: 347
Likes: 0
From: Virginia Beach, VA
Car: 1985 Firebird S/E
Engine: SBC 350, mild cam Vortec heads
Transmission: Rebuilt 700R4 vette servo+shift kit
Axle/Gears: 3.73
Re: Will these work?
rear drivers side
Thread
Thread Starter
Forum
Replies
Last Post
Terrell351
Engine/Drivetrain/Suspension Parts for Sale
5
Jun 13, 2021 01:13 PM