threads ??
Thread Starter
Supreme Member
Joined: May 2005
Posts: 1,701
Likes: 0
From: San Diego, CA
Car: 1991 Camaro RS
Engine: LO3
Transmission: 700R4
Axle/Gears: 3.42 LS1
threads ??
LS1 rear end conversion, with stainless steel braided lines.
My question is, what's the thread of the hardline going from the car (ie underneath the car all way back) ?
And the thread of the line going from the T-block ?
These two meet together, they meet fine but due to the bracket I would like to get a small fitting, ie extension in there, right now it's kinda tight and I could cut the bracket but would prefer to fun a small extension instead.
My question is, what's the thread of the hardline going from the car (ie underneath the car all way back) ?
And the thread of the line going from the T-block ?
These two meet together, they meet fine but due to the bracket I would like to get a small fitting, ie extension in there, right now it's kinda tight and I could cut the bracket but would prefer to fun a small extension instead.
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
May 17, 2020 10:44 AM
Elephantismo
Electronics
14
Feb 13, 2019 12:51 AM
355tpipickup
Tech / General Engine
5
Sep 28, 2015 05:50 PM
Linson
Auto Detailing and Appearance
26
Sep 21, 2015 01:08 PM