LS1 rear end conversion, with stainless steel braided lines.
My question is, what's the thread of the hardline going from the car (ie underneath the car all way back) ?
And the thread of the line going from the T-block ?
These two meet together, they meet fine but due to the bracket I would like to get a small fitting, ie extension in there, right now it's kinda tight and I could cut the bracket but would prefer to fun a small extension instead.
My question is, what's the thread of the hardline going from the car (ie underneath the car all way back) ?
And the thread of the line going from the T-block ?
These two meet together, they meet fine but due to the bracket I would like to get a small fitting, ie extension in there, right now it's kinda tight and I could cut the bracket but would prefer to fun a small extension instead.
i "think" its 12mm 1.0, but in not sure