LS1 conversion bracket question
Thread Starter
Joined: Sep 2007
Posts: 640
Likes: 3
From: Northern California
Car: 1985 California Iroc
Engine: HSR ZZ4 0411 swapped
Transmission: 4L60E
Axle/Gears: 3.23 posi
LS1 conversion bracket question
I will be cutting my own brackets for a swap. I need to know the correct thickness Steel plate I’ll need. Thanks
Joined: Nov 2018
Posts: 247
Likes: 117
From: Kylertown,PA
Car: 85 Berlinetta
Engine: 350
Transmission: T5
Axle/Gears: 10 bolt 3.42 with Torsen posi
Supreme Member
Joined: Jun 2002
Posts: 2,227
Likes: 46
From: North East GA
Car: 1989 Firebird
Engine: 5.7 LS1
Transmission: T56
Re: LS1 conversion bracket question
Actually the thickness can vary I had bigbrakeupgrade make me a skinner set so that my rotor was center in the caliper carrier. If cutting it your self I would mock it up and figure out the exact thickness you need to center the carrier on the rotor.
Thread Starter
Joined: Sep 2007
Posts: 640
Likes: 3
From: Northern California
Car: 1985 California Iroc
Engine: HSR ZZ4 0411 swapped
Transmission: 4L60E
Axle/Gears: 3.23 posi
Re: LS1 conversion bracket question
Was your set 5/16” thick?
Thread
Thread Starter
Forum
Replies
Last Post
