Atten Grumpy

Reply Subscribe

Thread Tools

Search this Thread

Mar 27, 2001 | 05:05 PM

SATURN5

Thread Starter

Supreme Member

Joined: Jun 2000

Posts: 1,612

Likes: 0

From: the garage

Car: 84 SVO

Engine: Volvo headed 2.3T

Transmission: WCT5

Axle/Gears: 8.8" 3.73

Atten Grumpy

Lo, sorry I missed POWWOW II but I can hardly wait for the next one. I havea question regarding SyTY software on a 730. First do I need a TPI memcal or one from a SyTy? Second is there any changes needed to the software other then Knumcyl and injector rates for it to run? Hope to have it all ready in the next few weeks..(the return is in...hehe). Thanks for your time, Bob Ward

------------------
79 Chevy Malibu Cpe
305 TPI/700-R4,
Custom Turbocharged,
ported upper and lower intake,
214,224 duration .450I .465E lift
730ECM,SyTy software,custom eprom,
Website:
www.turbotpi.homestead.com/SATURN5.html

Mar 27, 2001 | 07:47 PM

Grumpy

Supreme Member

Joined: Jun 2000

Posts: 7,554

Likes: 1

From: In reality

Car: An Ol Buick

Engine: Vsick

Transmission: Janis Tranny Yank Converter

Quote:

<font face="Verdana, Arial" size="2">Originally posted by SATURN5:
Lo, sorry I missed POWWOW II but I can hardly wait for the next one. I havea question regarding SyTY software on a 730. First do I need a TPI memcal or one from a SyTy? Second is there any changes needed to the software other then Knumcyl and injector rates for it to run? Hope to have it all ready in the next few weeks..(the return is in...hehe). Thanks for your time, Bob Ward
</font>

Need to use a syty memcal, that sets the hardware, and limphome mode.
Then yes cylinder select.

There are some indios about using it, TCC moves and no wastegate. Ther details are in the GMecm and DIY-EFI archives, I lost my notes in a PC crash, so there is hunting goning to be need.
I think Intech (was posting here) has done a few of these