Im new to this and when I go to the aldl values screen I only get a few readings under a header that says general. How can I get more to show like I've seen in screen shots. Also I have heard I am supposed to tune in open loop but cant find where I increase the temp so It wont go into closed loop.

 

What mask file are you running? 32? 32B? 6E?

 

If you're referring to your 1987 TPI, then you "should" have a $32B code mask. Sounds like, from what little you have told us, that you have a bad or wrong definition. Try going to Tunperpro's website and re-downloading the correct 32B file, and let us know how it goes.

 

I started with 32b but then switched to 6e and ive got everything now. is It a problem that my bin is a 32b and I datalog with a 6e definition.

 

If you are asking if it is a problem, yes that is a problem. You must have a 32B bin with 32B definition, get a 6E bin with 6E definition (I did the exact same switch myself) and just copy over all the tables, or hand edit them to what you had on the 32B code. OR, you could just start fresh and tune your engine from a stock 6E bin. Your call, but you can't mix and match bins/definitions. If you want a nice dash setup (for tunerpro 5) for that 6E definition just let me know