I know we have killed this question, and yes searched but didn't find the answer. K got this door to replace mine, it had power windows that work, got a switch for it. No heres the problem I don't have a harness but will just use normal conectors for it. I don't know how the wires should link up to the switch

UP
______
] ]

] ]
______

Down

Using this simple diagram what wire goes where?

Thanks guys


Rich

 

bump

 

UP
______


D B
C A
______

Down


A=window up
B=window down
C=ground
D= 12V key power

 

Where do I get the power wire from. Can I use 14 and 18 gauge wire left overs......Thanks.

 

I would run a wire from the fuse box. 14 guage would probably be your best bet. As you are looking at the fuse box on the right side between the heater/ac and stop/hazard fuses you should see where the power windows ckt breaker would be, the opening just above a metal can that shaped like a fuse marked PWR ACC. One side will have power with the key on, tap into the other side for your power wire to the switches. You should get a 35Amp circuit breaker to put in the fuse box. Any parts house should have them.

 

would I need to pull the full box down to do this or will it be pretty easy? This is the fist of this type of thing to do.

 

bump

 

Quit killing yourself,......... I've installed this set-up in an 86 and a 91 in the last month and it's pretty easy if you have the right stuff.



$20 + shipping.

* Buttons are $7 each

If your car is an 82-89 it will have a power junction bok behind the drivers kick panel. Plug this harness into the junction box and your done. Your fusebox is already wired and all you need to do is place a circuit breaker in the correct slot. ( looks like a metal fuse. )

I've also got a harness for Windows and locks as well for $35 + shiping.



If your interested just post your ZIP and I'll get a shipping qoute for you.

 

66213