turn signals not working!! need help
#1
Supreme Member
Thread Starter
iTrader: (3)
Join Date: May 2005
Location: Southern IL
Posts: 1,942
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 GTA "Cocaine"
Engine: 350 tpi
Transmission: 700r4
Axle/Gears: 3.27
turn signals not working!! need help
the parking lights work
brake lights work
back up lights work
hazards work
when I try to use the turn signals I dont get anything from the dash and the flashers do not work
tried to replace the flasher with no avial
tried to replace the turn/flasher switch in the column and no go
it has to be a wiring problem and I need help
thanks!!!
brake lights work
back up lights work
hazards work
when I try to use the turn signals I dont get anything from the dash and the flashers do not work
tried to replace the flasher with no avial
tried to replace the turn/flasher switch in the column and no go
it has to be a wiring problem and I need help
thanks!!!
#3
Senior Member
Join Date: Jan 2009
Location: DE
Posts: 611
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1990 Firebird Formula
Engine: LB9 - 5.0 TPI
Transmission: 700R4
Axle/Gears: 2.73, LSD
Re: turn signals not working!! need help
I'm having the same problem. Just happened about 10 minutes ago, my turn signals have always worked until now. My passenger side turn signal still works but for some reason the driver side just stays lit when I turn on the left signal.
#4
Junior Member
Join Date: Sep 2009
Location: 47874
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Car: 1984 Black Trans Am
Engine: 350 bored .030
Transmission: 700r4
Axle/Gears: Stock. Wanting up grade
Re: turn signals not working!! need help
I would definitely check the bulbs. In my firebird my front passenger side turn signal would not work, would turn on in the dash, but not on the outside, and wouldnt flash. replaced the bulb, BOOM, turn signals. Also, before replacing, take it out, clean it, then put it back in there. did that to all of my brake light bulbs, made 3 work that didnt before, then again my car sat for 3 years. Good luck
#5
Senior Member
Join Date: Jan 2009
Location: DE
Posts: 611
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1990 Firebird Formula
Engine: LB9 - 5.0 TPI
Transmission: 700R4
Axle/Gears: 2.73, LSD
Re: turn signals not working!! need help
The thing is every light on the outside of my car works. I had that same problem you mentioned. But even on my dash when I turn on my turn signal it doesn't flash. It just stays lit. I'm hoping its that little turn signal relay that clicks under the dash.
#6
Supreme Member
Thread Starter
iTrader: (3)
Join Date: May 2005
Location: Southern IL
Posts: 1,942
Likes: 0
Received 0 Likes
on
0 Posts
Car: 88 GTA "Cocaine"
Engine: 350 tpi
Transmission: 700r4
Axle/Gears: 3.27
Re: turn signals not working!! need help
mr froman you need to change the flasher
the lights on the dash do not work right or left
the lights around the car work with the headlight switch
the hazard switch turns on the flashers on the dash and all the outside lights
please give me some advise besides change the bulbs
the lights on the dash do not work right or left
the lights around the car work with the headlight switch
the hazard switch turns on the flashers on the dash and all the outside lights
please give me some advise besides change the bulbs
#7
Senior Member
Join Date: Jan 2009
Location: DE
Posts: 611
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1990 Firebird Formula
Engine: LB9 - 5.0 TPI
Transmission: 700R4
Axle/Gears: 2.73, LSD
Re: turn signals not working!! need help
I picked up a flasher today and now it flashes, but any amber colored driver side light won't light up when I go to turn on my lights. They work for the turning signal, but for some reason the left turn signal light on the dash stays lit but won't turn on outside of the car when I turn on my headlights/running lights.
So in other words, the amber lights work only as turning signals.
So in other words, the amber lights work only as turning signals.
Trending Topics
#8
Re: turn signals not working!! need help
I have the same problem no turn signals or flashers got two new fuses but can't even find the so call drop down panel were they are surrpose to go, and please don't tell me under the dash, tell me were under the dash. so i can start from their. thanks for your help
#11
Senior Member
Join Date: Jan 2009
Location: DE
Posts: 611
Likes: 0
Received 2 Likes
on
2 Posts
Car: 1990 Firebird Formula
Engine: LB9 - 5.0 TPI
Transmission: 700R4
Axle/Gears: 2.73, LSD
Re: turn signals not working!! need help
If you look under the dash, you'll see this little round silver thing. That is what clicks when you turn on your turn signal and allows it to blink you can unplug that and put a new one in. Picked one up at NAPA for $3.
#12
Senior Member
Join Date: Jul 2007
Location: Elk Grove Village
Posts: 637
Likes: 0
Received 0 Likes
on
0 Posts
Car: Firechicken
Engine: 350 + 30 over, 400 crank
Transmission: autotragic, stalled
Axle/Gears: not a one tire fire, thank god!
Re: turn signals not working!! need help
I have the same problem and replaced the flasher, it didn't help. I want to know how to do this also. I did notice that when I have my hazards on, they don't all blink together. Also the rear passenger light stays lit when I want to make a turn, but the front marker and parking light don't light up at all. I need help with this also. I replaced the bulbs, and the flasher but can't find anything else wrong. All the fuses are fine, (I got the glows when it blows fuses) and still have issues.
#13
Supreme Member
Re: turn signals not working!! need help
I have problems as well. Turn signals work with the headlights off, or on the hazard lights, but not with the lights on. No idea what is wrong. It is and 86 with the amber turn signals in the rear, which I don't think it came with.
#14
Re: turn signals not working!! need help
I got the new fuses flasher and signal (same) But i can't find them under the dash any where, I'll start looking for lose connection's i guess
#15
Senior Member
Join Date: Jul 2007
Location: Elk Grove Village
Posts: 637
Likes: 0
Received 0 Likes
on
0 Posts
Car: Firechicken
Engine: 350 + 30 over, 400 crank
Transmission: autotragic, stalled
Axle/Gears: not a one tire fire, thank god!
Re: turn signals not working!! need help
I'm giving this a bump. I still haven't figured out the problem and was hoping someone here could shed some light on the subject. Anyone got any info.
#16
Senior Member
iTrader: (8)
Join Date: Jun 2009
Location: Peoria, AZ
Posts: 768
Likes: 0
Received 2 Likes
on
2 Posts
Car: 91 Z28, 2000 T/A
Engine: SBC 355, LS1
Transmission: T56, T56
Axle/Gears: 10bolt 3.73, 3.42
Re: turn signals not working!! need help
I picked up a flasher today and now it flashes, but any amber colored driver side light won't light up when I go to turn on my lights. They work for the turning signal, but for some reason the left turn signal light on the dash stays lit but won't turn on outside of the car when I turn on my headlights/running lights.
So in other words, the amber lights work only as turning signals.
So in other words, the amber lights work only as turning signals.
#17
Senior Member
iTrader: (8)
Join Date: Jun 2009
Location: Peoria, AZ
Posts: 768
Likes: 0
Received 2 Likes
on
2 Posts
Car: 91 Z28, 2000 T/A
Engine: SBC 355, LS1
Transmission: T56, T56
Axle/Gears: 10bolt 3.73, 3.42
Re: turn signals not working!! need help
Hazard/turn and for the rear the brakelights all use the same filament in the bulb. so if the hazard make all 4 light's work the bulbs aren't the problem.
Last edited by 3rd gen Will; 10-07-2009 at 12:48 PM.
#18
Senior Member
Join Date: Jul 2007
Location: Elk Grove Village
Posts: 637
Likes: 0
Received 0 Likes
on
0 Posts
Car: Firechicken
Engine: 350 + 30 over, 400 crank
Transmission: autotragic, stalled
Axle/Gears: not a one tire fire, thank god!
Re: turn signals not working!! need help
thankyou for that 3rd gen will, but I'm wondering (I still have my problem) if a filament that is burned out, cause the interior turn signal indicator light to stay on when the lights turn on or when you try to make a turn in that direction. That is my problem right now. Anyone have an idea how to fix it? Where are the electrical gurus?
#19
Senior Member
Join Date: Jul 2007
Location: Elk Grove Village
Posts: 637
Likes: 0
Received 0 Likes
on
0 Posts
Car: Firechicken
Engine: 350 + 30 over, 400 crank
Transmission: autotragic, stalled
Axle/Gears: not a one tire fire, thank god!
Re: turn signals not working!! need help
Sorry for the bump but I still have the same problem and need help from the electrical gurus. Where are you guys? Thanks for any help in advance.
#20
Junior Member
Join Date: Jul 2002
Location: central North Carolina
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Re: turn signals not working!! need help
Everyone please remember that there are TWO flashers. One for the hazard circuit and one for the turn signals. Don't confuse the hazard flasher for the turn flasher. Usually the hazard flasher is located in or close to the fuse block. The turn signal flasher is usually clipped onto a bracket close to the steering column. Why do they put it there? So there is tactile feedback from the clicking of the flasher and so the sound of the clicking is noticeable. I do know that when a flasher goes bad all the symptoms you described match.
Last edited by Mike M; 10-09-2009 at 09:00 AM. Reason: spelling
#21
Senior Member
Join Date: Jul 2007
Location: Elk Grove Village
Posts: 637
Likes: 0
Received 0 Likes
on
0 Posts
Car: Firechicken
Engine: 350 + 30 over, 400 crank
Transmission: autotragic, stalled
Axle/Gears: not a one tire fire, thank god!
Re: turn signals not working!! need help
I get that, but what happens when you replaced both flashers, and all the light bulbs (my dumb *** broke a few taken them out to test them so I had to replace almost all of them!) and you still have the same problem? Where do you go to next? That is what I mean, sorry for the confusion, this S--T is annoying!
#23
Senior Member
Join Date: Jul 2007
Location: Elk Grove Village
Posts: 637
Likes: 0
Received 0 Likes
on
0 Posts
Car: Firechicken
Engine: 350 + 30 over, 400 crank
Transmission: autotragic, stalled
Axle/Gears: not a one tire fire, thank god!
Re: turn signals not working!! need help
That sounds like a female dog. This sucks.
#24
Senior Member
iTrader: (8)
Join Date: Jun 2009
Location: Peoria, AZ
Posts: 768
Likes: 0
Received 2 Likes
on
2 Posts
Car: 91 Z28, 2000 T/A
Engine: SBC 355, LS1
Transmission: T56, T56
Axle/Gears: 10bolt 3.73, 3.42
Re: turn signals not working!! need help
Easy way to check, disconnect the switch at the column turn your headlights on and see if the dash indicator illuminates.
#25
Senior Member
Join Date: Jul 2007
Location: Elk Grove Village
Posts: 637
Likes: 0
Received 0 Likes
on
0 Posts
Car: Firechicken
Engine: 350 + 30 over, 400 crank
Transmission: autotragic, stalled
Axle/Gears: not a one tire fire, thank god!
Re: turn signals not working!! need help
I really need a write up for this. Please tell me some one has done this crud before. Help and thanks.
#26
Supreme Member
Re: turn signals not working!! need help
OK I know the flashers are ok the signals work when the lights are off. When the lights are on they don't blink. Nothing happens with the dash. I have the amber turnsignals in the rear. It is an 86 Firebird which I recently bought so I don't even know whether or not the tails are stock or from another car.
#27
Junior Member
Join Date: Aug 2018
Location: CA
Posts: 11
Likes: 0
Received 1 Like
on
1 Post
Car: 86 firebird TA
Engine: 305 4 bbl carb
Transmission: 5 speed
Re: turn signals not working!! need help Also
Hi everyone:
I have an 86 firebird that the turn signal lights don't work, they just stopped.
I replaced the relay (bought 2 so I have a spare) and checked all the fuses, Hazard lights work, brake lights work, tail lights work, parking lights work. green arrows on dash don't light up. ether right or left. but work for hazards.
don't know what to do now any help would be appriciated
Thanks
I have an 86 firebird that the turn signal lights don't work, they just stopped.
I replaced the relay (bought 2 so I have a spare) and checked all the fuses, Hazard lights work, brake lights work, tail lights work, parking lights work. green arrows on dash don't light up. ether right or left. but work for hazards.
don't know what to do now any help would be appriciated
Thanks
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
10
08-11-2015 10:11 PM