ok both my seats lumbar dosent work, i press the buttons but i hear nothing, now i only care about deflating my seat... any way i can do that? also is there a fuse or a relay that could be gone??? thanks

 

The fuse is an inline fuse located under the driver's seat.

The middle pic in this post shows the fuse.

https://www.thirdgen.org/forums/post...75-post18.html

 

thanks for the info, but how hard is it to locate? do i need to take the seat out or can i just the carpet and get at it?

 

Well I took the seat out to help another member figure something out. Judging from the picture, I think you could probably just reach under and find it.

 

Well I just went out and checked and I was able to get to the fuse by moving the seat all the way forward and face-planting on the rear carpet.

 

thanks, i found it and i took out the fuse but it was good, i guess maybe the pump quit working on both sides that is !!! ok whats the best way to deflate the seat then? i have too much lumbar...

 

The pump, which is the big black box mounted under the front area of the driver's seat, is used for both seats. There is only 1 pump. I do not know how to deflate the seats without the button working. You could try disconnecting the hoses.

 

yeah i see the pump, i guess its not working....im gonna try unplugging the hose i guess and see what happens, now with the seat fully deflated u dont think its gonna be too uncomfortable do u ? cause there is no turning back after unplug the hose and deflate it....

 

No I don't think it will be uncomfortable at all. If removing the hose works, then just pull the hose, let some air escape, and re-attach the hose until you reach your desired firmness. Or get a pump at the JY.

 

thanks for ur input, im gonna unplug that hose here when i have some time.