No wipers or turn signals

Reply Subscribe

Thread Tools

Search this Thread

May 30, 2012 | 12:54 PM

midge54

Thread Starter

Member

Joined: Mar 2010

Posts: 317

Likes: 2

From: Pennsylvania

Car: 86 Trans am

Engine: LG4

Transmission: T-5

Axle/Gears: 3.27 9 bolt posi

No wipers or turn signals

Im working on getting my 84 trans am ready for state inspection so I can drive it on the road. My issue is my wipers won't work and neither will my turn signals. I have brake lights and my hazards work. Does the lever need replaced or is it something else

Jun 12, 2012 | 07:45 PM

Burbo

Junior Member

Joined: Mar 2009

Posts: 44

Likes: 0

Re: No wipers or turn signals

Well i don't have turn signals either (1991 Camaro Z28, L98/700R4) I didn't check my wipers but will very soon, Flashers work Checked all fuse with fuse tester. Now im at the convenice center, replaced hazard but i am missing two fuses or relays, or resistors, on the convenice center/panel. Get this went to the local GM dealer today and they no idea, it's not in their computer, and they haven't had parts books to look things up sence the 1980s, Guess I'll head over to NAPA tomorrow Good luck

Jun 13, 2012 | 06:45 PM

Burbo

Junior Member

Joined: Mar 2009

Posts: 44

Likes: 0

Re: No wipers or turn signals

Quote:

Originally Posted by Burbo

Well the wipers work, went to parts store and he couldn't tell either but their is a stand alone flasher resistor under the steering column 1" dia which i have changed. My next step is to check wires and ground wires at each maker Keep Pluging

Jun 14, 2012 | 08:00 PM

Burbo

Junior Member

Joined: Mar 2009

Posts: 44

Likes: 0

Re: No wipers or turn signals

Well got the turn signals working changed the fuse in the fuse panel (old fuse looked fine to me) Well good luck

Jun 18, 2012 | 04:14 PM

NINÅ

Supreme Member

Joined: Jan 2006

Posts: 3,341

Likes: 10

From: Mooresville NC

Car: LOWERED ♦ CRIMSON METALFLAKE

Engine: ► 400 KUBES ◄

Transmission: 765R4

Axle/Gears: EATON POSI 4.56

Turn Learn

Quote:

Originally Posted by midge54

Does the lever need replaced……..

Here’s how to find out.

With the key in the RUN position use a voltmeter or test light (the type for testing for voltage, not a continuity tester) to probe the purple wire at the steering column connector located near the lower right of the column.

If there’s no power there post same.

If there’s power there probe the light blue wire at the turn signal switch.

Is there power there?

If not, replace the switch.

◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙
Happy Racing!
◙◙◙◙◙◙◙◙◙◙◙◙◙◙◙

I Didn’t Jump The Start, The Flagman Was Late

.