2. Holley 750 Ultra HP Carb, billet metering block and base plate, brand new never run, carb costs almost $1000 new $600

3. Nitrous outlet 4 solenoid direct port kit with 15# upgraded bottle, NIB, costs $1039 new $800

4. FJO 2 stage progressive controller, window switch, tps switch. NIB, Costs $206 new $170

5. Weld Draglites 2 15x10 5.5bs , 2 15x3.5 1.75bs, all on 5x 4 3/4 bolt pattern, New tires with less than 500 miles on them, $600 pickup only

6. 1995 camaro Z28 roller, needs front bumper cover and hood. Engine, Tranny and wiring harness have been removed as well as the dash and center console and peddle assembly, 6 speed car. Clear title, Great paint, t-tops, Would make a great race car $300 pickup only

7. 305tpi/700r4 out of a 1991 Z28 (speed density) With computer and mint/unmolested harness, Complete from top to bottom, front to back 86k miles on it, still in car and runs perfect, tranny shifts fine. $550 for all . pickup only

8. Moser 9" rear end for fbody. Set up for 3rd gen "big" ford ends, 3" tubes, T/A bracket, Back brace welded on, ARP carrier studs, painted with VHT black caliper paint $1100 new $700

9. Complete dash and center console from 91 z28. In decent shape, console could use new carpet on the sides, all guages work Make offer. pickup only

10. Bell A/A intercooler, 28x8.5x3 with 2.5" in/out. Fits perfect between front bumper of a stang or camaro with minimal trimming. $125


have pics of most everything, pm me or email me ncmarine6116@yahoo.com

Things I need:

6" pin on cowl hood for 82-92 camaro
electric water pump for sbc
victor jr. intake for sbc
carb hat, either EV or CSU
12 gallon sumped fuel cell
3" vband flanges/clamps

 

How much for the speed density harness and computer?

 

I could use the plenum and TB if you are parting the engine out... and understand if you want to wait and see if the whole setup sells before deciding also....

Thanks
Bill

 

make an offer on the parts you want

 

Can you get me a quote on shipping for the motor and tranny combo to 78748?

 

How much for #5 shipped to Calgary, Alberta, Canada, T2Z 4V8? (preferrably USPS)

Thanks

 

do you have pics of the cowl

 

sorry not looking to ship any of the big stuff

sorry, not going to ship any of the bigger stuff

dont have a cowl?

 

Sorry got excited and missed the pick up only part....

 

For #8, what do you mean by "Big" ford end? What gears are in it? Is it basically ready to bolt in?