Dropped one of the middle dashboard screws, does it matter?
Thread Starter
Member
Joined: Sep 2012
Posts: 236
Likes: 0
From: CA
Car: 92 RS
Engine: 305 TBI
Dropped one of the middle dashboard screws, does it matter?
Does it matter? I dropped one of the middle screws of the dashboard towards the back of it. I tried to use a magnetic grabber but I couldnt find the screw. Does it matter? It doesnt look like it would go down a heater hose
Member
Joined: Sep 2006
Posts: 164
Likes: 0
From: Birmingham, MI
Car: 1983 Crossfire Recaro T/A
Engine: 5.0L Crossfire
Transmission: Upgraded 700R4
Axle/Gears: 3:23
Re: Dropped one of the middle dashboard screws, does it matter?
Are you saying that you dropped one of the screws down the defroster ducts?
Member
Joined: Sep 2006
Posts: 164
Likes: 0
From: Birmingham, MI
Car: 1983 Crossfire Recaro T/A
Engine: 5.0L Crossfire
Transmission: Upgraded 700R4
Axle/Gears: 3:23
Re: Dropped one of the middle dashboard screws, does it matter?
Not sure if it is the same as my '83 TA, but I actually dropped the nut driver bit and a short 1/4" extension that I was using to tighten the screw down the defroster vent when I was installing my dash.
Was pissed and figured I would surely screw something up.
A few days later I hit a bump and the bit and extension fell out of the floor vent!
Hopefully you will be as lucky!
Was pissed and figured I would surely screw something up.
A few days later I hit a bump and the bit and extension fell out of the floor vent!
Hopefully you will be as lucky!
Thread
Thread Starter
Forum
Replies
Last Post
wigmobile
Electronics
5
Feb 26, 2025 02:56 PM
gta892000
Cooling
6
Sep 16, 2015 12:37 AM