i need a 305 or 350 engine in good running condition.intake is not needed. and heads are not mandatory. im located in marysville and could pick up.thanks

 

anyone?

 

Wish you were closer, i have a good 305 block with heads and intake I need gone. Id let it go for 100 if you can get it shipped.

 

How much are you willing to spend? I have a short block I would sell but aint cheap.

 

What's "not cheap"? I may be in the market for a short block. Pm me the details.

 

I have to pull out the engine to get all details but it's an L98 block bored .030 over with forged piston, comp cams, gear drive. I'll keep the gear drive since it's not a "knock sensor" friendly especially if you're running boost. I might be pulling it out sometime this month. Just have to many "honey to do" list. How soon do you need one? If you're really interested and we can agree on a price, I can pull it out sooner. What I mean by not cheap is that the price is closer to $1000 than to $100. I'm not saying I'm asking $1000 either.

 

im really not in the market for a 1000 dollar (or close to it) engine. especially if its not complete. but thanks for the response. -art

 

I'm interested you know what the CR is/was, how many miles, stock crank and rods? I wouldn't need the cam or timing set. I would like to have the bird running by the meet but in not in a rush. If it happens great if not Owell.

 

I know 1 for 600 or possibly even cheaper.

 

I would have to take a peak at the piston. I was told it has less than 20k mile on it. I believe it has stock crank and rods. Why don't I just build a short block for you reusing you block and crank and maybe even your rods so we can build it to your spec.

Ooppps sorry for the hi-jack. I'll pm the rest from now.

 

thats what in talking about. i dont need anything special, but i do want a roller block. oh, the engine will be replacing the stock 230ci in my 67 short fleet along with the 700r4 which i rebuilt in school. so fuel injection manifold is not needed.

 

I have a 355 out of an 89 suburban. It is machined for roller but i don't have the roller parts. It has a new comp cam and lifters. Not sure if you're interested still but I would let it go for 550.

 

if you were closer i might have taken it.

 

hmmm i think i might have a motor u can use. its a 307 out of my 1968 el camino.

 

just picked up a 99 5.7L vortec. complete. i want to run a carb. will the stock cam be any good with a carb?

 

ya it will be fine.