Need help End links
Thread Starter
Junior Member
Joined: Sep 2009
Posts: 12
Likes: 0
Car: 91 RS
Engine: 350 Carb
Transmission: TH-350
Axle/Gears: Stock 3.23
Need help End links
Just swapping out end links today. 91 RS. No matter how I jack the car or put a load on it, It seems the end links are too short. I ran the part numbers, they are correct. Any help would be appreciated.
Joined: Aug 2006
Posts: 12,804
Likes: 103
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: Need help End links
front or rear?
front, with the suspension loaded on both sides, they should work just fine, rear, depending on what length was there before, you may have to loosen the mounts on the axle, then put the links on, then retighten the axle mounts, with the suspension load of course.
front, with the suspension loaded on both sides, they should work just fine, rear, depending on what length was there before, you may have to loosen the mounts on the axle, then put the links on, then retighten the axle mounts, with the suspension load of course.
Supreme Member
iTrader: (3)
Joined: Jun 2007
Posts: 2,359
Likes: 5
From: Pennsylvania
Car: 1992 Camaro RS
Engine: Rebuilt 350 going in after paint
Transmission: WCT5, 7k & counting behind the 350
Axle/Gears: 4thgen disc rear w/ 3.73 Posi
Re: Need help End links
I've run into that before. You need to loosen the 4 sway bar-to-frame mounting bolts(2 per side) slightly so that you can pivot the bar down enough to get the nuts started. Once you have both sides started you tighten up those 4 bolts then torque the end links to spec.
Thread
Thread Starter
Forum
Replies
Last Post
1992rs/ss
NW Indiana and South Chicago Suburb
14
Jan 31, 2025 05:10 PM
1992rs/ss
Engine/Drivetrain/Suspension Parts for Sale
16
Jan 28, 2016 09:58 PM
db057
TBI
10
Aug 11, 2015 10:11 PM