I have a very poor memory.

I am doing the motor on my 305 TBI. (Converting to a 350.)

Well, its going back together, but I have a bracket that I dont know where it goes. Can someone take pics of their intake for me? With the air cleaner assembly completely off and somewhat close pics. I am going to use it as a referece to get that bracket in the right place and get the vacumn lines back on right.

TIA.

 

This isn't a very good pic for what you want, but it's a start, did you try a search. In this pic the brackets for lifting the engine are gone and I relocated the "heater valve?" towards the back. The one plugged vacuum line is the one that goes to the heat stove valve.

 

Can you get one REALLY close up on the passenger side? Like, 2' away? The bracket is nowhere in the chiltons book. I can find the vacumn crap in chiltons though.

 

I have no brackets on the pass side, There was a engine lift bracket there with 2 holes in it and there's a little electrical connector with vacuum lines coming in and out, one goes to the EGR, mine is just lying there though, no bracket.

 

Can you describe what it looks like or post a pic?

I just re-installed my motor and may be able to identify it.

S-D

 

I'll have to do that tommorow.

 

There is a bracket on the passenger side that holds the EGR solinoid. Is that what you need a pic of?

 

I have a bracket that holds a little vacuum module on the rear passengers side- has two vacuum lines connecting to it (side by side) and one 2-wire electrical connector on the opposite end.
It mounted on a small braket that mounts to the rear hoisting bracket.

This wouldn't work with my set-up so I made my own bracket. I had to modify a lot of my old 305 brakets to fit the new vortec bolt pattern (engine hoist brackets and so on..).

A pic would help volumes---
Best
S-D

 

That was it.

Thanks.