What should I do? I got a 350 5.7L from a 1991 chevy 1500 silverado w/ computer, so i'm swapping it over to my camaro, but i'm wanting to do a little work to it, what would be the best options for this tbi to get more power?

 

Do you plan on doing any tuning? That will determine what can/should be done to the motor.

 

Would it be easy for me to know how to tune? I would prefer to tune later!

 

This thread was started to help those that are beginning tuning. after checking it out read the stickies in DIY-PROM. there is one there that give you more of a technical reference to tools you need and terms you will run across.

Easy? I stuggled with Geometry but found Algebra easy.

 

sucks its so expensive to work with the prom setups wish i knew someone that could teach me right here...

 

Ask a question and you will get an answer. This board has the experience.

All the help you need is waiting.

 

i just posted in the swap thread because now i'm questioning if its going to work. i'm swapping over the computer w/ prom and the complete 350 tbi engine from the 91 chevy silverado 1500 to my 89 camaro 305 tbi, anything i should look to be swapping or buying new? both have the 700r4's so i don't see a problem but maybe the wiring?

 

https://www.thirdgen.org/forums/tbi/...ucks-have.html

i pulled this up and a few others say don't have to worry, everything should be fine... but i'm still researching to get an exact idea.

 

ESC module or knock sensor from 350 cid
ignition module for 350 cid

I believe the harness-ECU is compatible. If not I recall Turbo City may sell an adapter? Check their site for info

89 camaro I think has IAT. check if the 91 truck has same. If not it has to be turned off in chip.bin