car stalls when clutch is in
car stalls when clutch is in
i have a '91 z28 5.0L
the car idles poorly, and it has times when it stalls out constantly. I'll be driving and when i press the clutch in, the rpms drop to 0 and the car stalls. It is only when the clutch is in that this happens. Any help would be appreciated.
the car idles poorly, and it has times when it stalls out constantly. I'll be driving and when i press the clutch in, the rpms drop to 0 and the car stalls. It is only when the clutch is in that this happens. Any help would be appreciated.
Member
Joined: Dec 2000
Posts: 408
Likes: 0
From: Chesterfield, VA
Car: '86 IROC, black and sharp
Engine: 305 tpi, bone stock
Transmission: 700r4
Axle/Gears: 3.42 pos w/rear db
Seems like I read somewhere that the EGR should be closed at idle rpms or the exhaust gas in the cylinder will result in the engine stalling. The code 32 also indicates and EGR system fault (I think).
------------------
Z's r Best
------------------
Z's r Best
32. Fault in barometric pressure sensor circuit OR
Fault in exhaust gas recirculation valve diagnostic switch OR
Fault in electronic vacuum regulator valve
Ya, I second checking the EGR. Hope this helps, go this from the list in the tech section.
------------------
1989 GTA 350 TPI
Stock:
- T-tops
- Dual cats
- 9-Bolt 7.75" Rearend
- 3.27 gears
Mods:
- Dynomax Super Turbo Muffler
- K&N Air Filter
1992 RS 305 TBI - Sold
Fault in exhaust gas recirculation valve diagnostic switch OR
Fault in electronic vacuum regulator valve
Ya, I second checking the EGR. Hope this helps, go this from the list in the tech section.
------------------
1989 GTA 350 TPI
Stock:
- T-tops
- Dual cats
- 9-Bolt 7.75" Rearend
- 3.27 gears
Mods:
- Dynomax Super Turbo Muffler
- K&N Air Filter
1992 RS 305 TBI - Sold
Thread
Thread Starter
Forum
Replies
Last Post
db057
TBI
10
Aug 11, 2015 10:11 PM
novaderrik
Transmissions and Drivetrain
3
Aug 10, 2015 12:44 PM
rsrmoore
Transmissions and Drivetrain
1
Aug 7, 2015 08:44 PM





