PA U pull it junkyards...any good ones?
Thread Starter
Junior Member
Joined: Nov 2009
Posts: 39
Likes: 0
From: Lancaster, PA
Car: 83 Z28
Engine: 355
PA U pull it junkyards...any good ones?
Hey guys, thought I would ask if and where PA has any good u pull it junkyards with 3rd gens sitting in them? Or northern MD or NJ for that matter, I will travel just would like it to be worth my time. Tried searching but it pulls up 10000 threads seemingly unrelated.
Joined: Mar 2007
Posts: 1,698
Likes: 3
From: NE Pennsylvania
Car: 85 Iroc-Z
Engine: 383 TPI Procharger D1SC
Transmission: TKO600
Axle/Gears: Strange S60 3.73
Re: PA U pull it junkyards...any good ones?
Harry's U Pull It is a decent you pull it yard.
Junior Member
Joined: Mar 2009
Posts: 51
Likes: 0
From: nazareth pa
Car: 98 blazer 4x4 lifted 3inches
Engine: 4.3
Transmission: auto
Axle/Gears: idk, but not a posi
Re: PA U pull it junkyards...any good ones?
he prices are good theirs a smaller one in allentown too but theirs this one place in wind gap called shaffers, its way back in the woods and these people are pretty backwoods, entire interior for 5 bucks front and back seats,t-top headliner and a panel or 2
Junior Member
Joined: May 2006
Posts: 13
Likes: 0
Car: 88 Camaro
Engine: '72 350
Transmission: 700R4
Axle/Gears: 4.10?
Re: PA U pull it junkyards...any good ones?
I was at Harry's back in early October, to grab a trans for my Dodge. They had two third gens. There's a u-pull it in New Ringgold and I was up there in early October and I counted over 12 third gens. Granted most were picked over, but there was still a good amount of useable parts on them. I was surprised at the lack of f-bodies at harry's. The one in New Ringgold had a way better selection.
Trending Topics
Thread Starter
Junior Member
Joined: Nov 2009
Posts: 39
Likes: 0
From: Lancaster, PA
Car: 83 Z28
Engine: 355
Re: PA U pull it junkyards...any good ones?
I was at Harry's back in early October, to grab a trans for my Dodge. They had two third gens. There's a u-pull it in New Ringgold and I was up there in early October and I counted over 12 third gens. Granted most were picked over, but there was still a good amount of useable parts on them. I was surprised at the lack of f-bodies at harry's. The one in New Ringgold had a way better selection.
which harrys were u at?
Junior Member
Joined: Aug 2009
Posts: 74
Likes: 0
Car: 89 Camaro
Engine: LB9
Transmission: 700R4
Axle/Gears: ?
Re: PA U pull it junkyards...any good ones?
Theres a few right outside of NE Philly up in Levittown and Bristol that usually have 3-5 3rd gens sitting around. Got a pair of headers and a y pipe for 20 bucks. Motors go for 75.
Theres a few south of the city too, but I never saw many 3rd gens there, and they can get a little sketchy...
Theres a few south of the city too, but I never saw many 3rd gens there, and they can get a little sketchy...
Junior Member
Joined: May 2006
Posts: 13
Likes: 0
Car: 88 Camaro
Engine: '72 350
Transmission: 700R4
Axle/Gears: 4.10?
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM
mdtoren
Tech / General Engine
0
Aug 16, 2015 05:45 PM






