3inch 1pc Crank into 2pc block???
Thread Starter
Junior Member
Joined: Apr 2014
Posts: 49
Likes: 0
From: Huntsville, Texas
Car: 1989 Camaro IROC-Z
Engine: LTx 305
Transmission: 700r4
Axle/Gears: stock w/2.73 :(
3inch 1pc Crank into 2pc block???
I have a left over 3in 1pc crank from my L99(4.3 V8) and have two non-roller cam 2pc 350 blocks laying around, I know they make an adaptor kit to put a 2pc crank into a 1pc block....would this kit work but just the other way around? Just a random question/thought I had today.
Supreme Member
Joined: Sep 1999
Posts: 7,072
Likes: 13
From: Philly, PA
Re: 3inch 1pc Crank into 2pc block???
I've seen it done the other way- adapting a 2-piece RMS crank into a one piece block, but I don't recall seeing a swap the other way.
Here's an old Hot Rod article about it:
http://www.hotrod.com/how-to/engine/...ear-main-seal/
Here's an old Hot Rod article about it:
http://www.hotrod.com/how-to/engine/...ear-main-seal/
Thread Starter
Junior Member
Joined: Apr 2014
Posts: 49
Likes: 0
From: Huntsville, Texas
Car: 1989 Camaro IROC-Z
Engine: LTx 305
Transmission: 700r4
Axle/Gears: stock w/2.73 :(
Re: 3inch 1pc Crank into 2pc block???
Yeah I was out messing around and tried to put the crank in place, wasn't fitting in the back end right.
Thread
Thread Starter
Forum
Replies
Last Post