Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Sponsored by:
Sponsored by: CARiD

bogging/ stalling/ high idle

Old Feb 5, 2019 | 04:31 PM
  #1  
lichowid91's Avatar
Thread Starter
Junior Member
 
Joined: Jun 2018
Posts: 19
Likes: 0
Car: 1990 RS Camaro
Engine: 305 TBI
Transmission: 700r4
bogging/ stalling/ high idle

I have a 90 RS 305 TBI car runs fine for about thirty minutes then starts to bog at random intervals even while accelerating sometimes if I feather the gas I can keep it going. If I let it sit for a while it will run fine again for a while even with the engine temp at operating temp. I'm thinking it may be the fuel pump; is it possible that the pump is running hot and starts to fail until I shut the car off for a bit?
Reply
Old Feb 5, 2019 | 05:02 PM
  #2  
Tuned Performance's Avatar
Sponsor
20 Year Member
Community Builder
Community Influencer
Community Favorite
iTrader: (94)
 
Joined: Dec 2004
Posts: 16,774
Likes: 1,002
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: bogging/ stalling/ high idle

You can check fuel pressure to illuminate the pump. It could also be the ignition control module in the distributor they commonly fail when heated up.
Reply
Old Feb 5, 2019 | 05:11 PM
  #3  
lichowid91's Avatar
Thread Starter
Junior Member
 
Joined: Jun 2018
Posts: 19
Likes: 0
Car: 1990 RS Camaro
Engine: 305 TBI
Transmission: 700r4
Re: bogging/ stalling/ high idle

I guess I should start with getting a fuel pressure valve (T bar valve I think) hook it between the TBI and fuel line right?
Reply
Old Feb 5, 2019 | 05:18 PM
  #4  
Tuned Performance's Avatar
Sponsor
20 Year Member
Community Builder
Community Influencer
Community Favorite
iTrader: (94)
 
Joined: Dec 2004
Posts: 16,774
Likes: 1,002
From: Mile High Country !!!
Car: 1967 Camaro, 91 z28
Engine: Lb9
Transmission: M20
Axle/Gears: J65 pbr on stock posi 10bolt
Re: bogging/ stalling/ high idle

Correct , some testers allow you to place where the fuel filter goes. Drivers side rear frame rail. I think tbi fuel pressure is 10-12psi.

Last edited by Tuned Performance; Feb 5, 2019 at 05:22 PM.
Reply
Old Feb 9, 2019 | 05:05 PM
  #5  
lichowid91's Avatar
Thread Starter
Junior Member
 
Joined: Jun 2018
Posts: 19
Likes: 0
Car: 1990 RS Camaro
Engine: 305 TBI
Transmission: 700r4
Re: bogging/ stalling/ high idle

I went ahead and tested it it stayed at 11 PSI, but it wasn't bogging at this point I have to drive it around for a bit before it will bog. On another note I was doing some research into the charcoal canister/ vapor canister and am focusing on that a bit because that sounds like that could be my issue as well. I can't find that much information on them nor do I really understand how it works. Anyways I have the enclosed canister I think from 89 and up does anyone know how to tell if those go bad or if there's a way to reuse it since it doesn't have a reusable filter?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
middian
Carburetors
19
Jan 28, 2016 08:00 PM
Zach/90\irocZ
TBI
14
Mar 13, 2012 08:15 AM
92 Rally
TBI
8
Jan 26, 2010 01:33 PM
Skatepunk60
V6
20
Feb 5, 2006 04:02 PM
Dapht Punk
Tech / General Engine
3
Aug 7, 2005 03:25 PM


Thread Tools
Search this Thread

All times are GMT -5. The time now is 02:05 AM.