TPI Tuned Port Injection discussion and questions. LB9 and L98 tech, porting, tuning, and bolt-on aftermarket products.
Sponsored by:
Sponsored by:

Car won't start

Thread Tools
 
Search this Thread
 
Old Apr 3, 2003 | 02:20 PM
  #1  
Tonyrodz's Avatar
Thread Starter
Supreme Member
 
Joined: Mar 2000
Posts: 1,611
Likes: 0
From: NJ
Transmission: auto
Car won't start

Not sure if this is the right forum..but..
I'm starting to play w/my T/A again--after sitting for a long time--it just won't start! It has fuel, inj.'s are firing but no spark! I took a known good coil from my Monte and swapped over-thinking that was the problem--still have no spark! all fuses look ok too.
I unplugged the passkey just for the hell of it-only the security light went out but still cranked--plugged it back on-security light was on(don't remember if it stayed on while cranking)and still won't start!! Car started and ran fine before I swapped my dash out(car is an 86 w/89 drivetrain and 92 dash).
I'm at a loss!! any help would be greatly appreciated!!
Reply
Old Apr 3, 2003 | 05:30 PM
  #2  
87ColdAirIroc-Z's Avatar
Member
 
Joined: Apr 2001
Posts: 159
Likes: 0
From: USA
Try replacing the ignition module, it is under the distributor cap,
Reply
Old Apr 3, 2003 | 05:33 PM
  #3  
Tonyrodz's Avatar
Thread Starter
Supreme Member
 
Joined: Mar 2000
Posts: 1,611
Likes: 0
From: NJ
Transmission: auto
Ok, I'll give it a shot. now my security light goes out! Before it was staying on all the time!!
Is there any way to check if a coil is bad? It's an Accel and I've already had one go bad on me(it's the remote coil).
Reply
Old Apr 5, 2003 | 10:22 PM
  #4  
TPI86TA's Avatar
Member
 
Joined: Mar 2003
Posts: 293
Likes: 0
From: Blackwood,NJ South Jersey
Car: 88 GTA
Engine: 350 TPI
Transmission: 700R4
I have to agree,it sounds like the ignition module.
Reply
Old Apr 5, 2003 | 10:26 PM
  #5  
Tonyrodz's Avatar
Thread Starter
Supreme Member
 
Joined: Mar 2000
Posts: 1,611
Likes: 0
From: NJ
Transmission: auto
Not that it really matters--but does anyone know what a decent(Accel, etc)ign module would go for and what would be a good/decent one to get? Never had one go bad on me before.
Reply
Old Apr 6, 2003 | 01:07 PM
  #6  
TPI86TA's Avatar
Member
 
Joined: Mar 2003
Posts: 293
Likes: 0
From: Blackwood,NJ South Jersey
Car: 88 GTA
Engine: 350 TPI
Transmission: 700R4
I know that if you want the one from Accel,it runs around $50 for one from Jegs.Jegs has their own brand module too and its supposed to be just as good and is about $10 cheaper i think.I dont know how the ones from MSD are,but i know they run about $70.In my Summit Racing catalog theres the one from Holley for about $60,and i think thats the one im gona go with.

By the way,you from NJ or PA?
Reply
Old Apr 6, 2003 | 01:28 PM
  #7  
Tonyrodz's Avatar
Thread Starter
Supreme Member
 
Joined: Mar 2000
Posts: 1,611
Likes: 0
From: NJ
Transmission: auto
Damn! That much??
I'm originally from NJ-but now Pa.
Reply
Old Jul 5, 2003 | 10:09 AM
  #8  
Tonyrodz's Avatar
Thread Starter
Supreme Member
 
Joined: Mar 2000
Posts: 1,611
Likes: 0
From: NJ
Transmission: auto
Had the ign module checked and it's fine--also not the vats--any ideas?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
midge54
LTX and LSX
21
Dec 27, 2019 04:14 PM
Brcharrelson
TPI
15
Aug 26, 2015 07:47 PM
justin57
TBI
30
Aug 20, 2015 07:05 PM
ZsTransAm
Electronics
1
Aug 11, 2015 07:30 PM
killer777
Tech / General Engine
0
Aug 8, 2015 02:47 PM




All times are GMT -5. The time now is 12:44 PM.